|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
More than pleased with my prurchase, very good product for the price.
;
Manual-link came 30 minutes after having paid for an extremely rare (40 years old) item (sony icr-120) and helped me to get the radio rework again. So really good help for me, fast and reliable delivery and -taken that into consideration- a very reasonable price for that service. So thanks again! Mike, Germany
 ;
Some of the pictures in this manual are a bit irritating. I had to dissassemble the unit and some of the screws have different threads, which is not mentioned in this manual. Also some of the drawings of the boards look different than the actual boards.
After all, the manual was very useful. I was able to recalibrate the capstan drive and it is working fine again.
;
This manual is very good. 303 pages scanned in a very high resolution. My camera has bad, leaking capacitors which all of the V5000 models are suffering from these days.
There is a huge part list with all capacitors, transistors etc. in this manual which helped me a lot. Otherwise I would not have been able to buy replacement parts.
The dissassembly guide is very enormous and detailed. Unlike on the Panasonic MS1 manual I downloaded here it actually looks like the real parts look. And the screws are labeled correctly, so you shouldn't have any left after the repair. ;)
;
has all the schematics you could need,and very well laid out format also has all part numbers along with an exploded view which is helpful
Convergence and Geometry adjustments
All of the displays are generated by the OTC, located on the SSB, except the GDE SAM Menu, which is generated by the Microprocessor located on the ACS Module. All of the settings except the GDE are stored in the NVM located on the SSB. The Geometry, White Tone, and Convergence settings are stored on the NVM located on the ACS Module. The GDE stores the settings for Geometry and White Tone. There is one setting stored for all modes in the GDE NVM. There are eight different alignment modes for Geometry and Convergence, which are stored in the GDE NVM. A chart of the Alignment modes is shown below. Mode 480p (NTSC Progressive) 1080i Line Frequency 31500 33750 Frame Frequency 60Hz 60Hz
It is important when adjusting Geometry or Convergence that the correct signal for that mode be applied to the set. Any time the Geometry is adjusted, the Convergence should also be adjusted. Failure to do so will result in an out of Convergence set when the customer uses the Intellisense feature.
Geometry Alignment
Completely read the Setup section before proceeding with any adjustment. The set should be allowed to warm up for at least 20 minutes before any adjustments are made. If the ACS module has been replaced, the following adjustments will be required in the order as shown: Geometry Convergence Grey Scale (White Tone) If the Large Signal Board (LSB) has been changed the following adjustment are required: Geometry Convergence If the CRTs have been changed: Geometry Convergence Grey Scale (White Tone) If the SSM (Small Signal Module has been changed: Convergence
|
|
|
> |
|
