|
Who's Online
There currently are 5727 guests and 3 members online.
|
Categories
|
Information
|
Featured Product
|
|
|
|
|
There are currently no product reviews.
;
There was no problem at all.After paying i had to wait only a few hours,than i could
download the manual in best pdf-quality.
Thank You !
;
I found this service manual to be complete in every detail except for troubleshooting charts. It would be helpful if it had a set of troubleshooting charts; however it is a very good manual otherwise and for the price it is very well worth it.
;
Complete manual included schematics layouts and alignment procedure, clear to read and magnify, extremely pleased with manual and owner manual . com's service
;
perfect, i am very satisfait for the réception of the sansui r-5l service manual, thank you very much
;
Thank you, this is a rare document. Few others have it, but they charge way more for a download.
Great deal (even if you have to wait a few hours to get it).
FLOW CHART NO.12 EV+3.3V is not outputted. Is 5V voltage supplied to the collector of Q1159? Yes Is the voltage of approximately 4V supplied to the base of Q1159? Yes Replace Q1159. No No Check D1108, L1105, C1120 and their periphery, and service it if defective. Check IC1153 and their periphery, and service it if defective.
FLOW CHART NO.13 P-ON+2.5V is not outputted. Is 4V voltage supplied to Pin(1) of IC1151? Yes Replace IC1151. No Check D1105, C1110 and their periphery, and service it if defective.
FLOW CHART NO.14 P-ON+3.3V is not outputted. Is 5V voltage supplied to Pin(1) of IC1152? Yes Replace IC1152. No Check D1108, L1101, C1114, C1116 and their periphery, and service it if defective.
FLOW CHART NO.15 The fluorescent display tube does not light up. No Is 3.3V voltage supplied to Pin(6, 24) of IC1503? Yes Is approximately -24V to -28V voltage supplied to Pin(15) of IC1503? Yes Is there approximately 500kHz oscillation to Pin(26) of IC1503? Yes Are the filament voltage applied between (1) and (24) of the fluorescent display tube? Also negative voltage applied between these pins and GND? Yes Replace the fluorescent display tube. No Check the -FL line and service it if defective. No Check the EV+3.3V line and service it if defective.
Check R1560, IC1503 and their periphery, and service it if defective. Check the power circuit, D1101, D1112, C1106 and their periphery, and service it if defective.
No
1-8-3
E7B71TR
|
|
|
> |
|