ONKYO DRL50
Owner's Manual

<Other than European model when set to [Interlace] setting in the Setup screen Video 1 menu and European model> Fine Focus
Switch [On] to reveal greater detail (higher resolution) in the picture.

I Adjusting the picture quality settings � To create your own setting (2)
1 Use the cursor button (3) to select [Start] then press ENTER.

Contrast
Adjusts the contrast of the elements in the picture.

Sharpness
Adjusts the sharpness of the high-frequency (detailed) elements in the picture. (This setting is only effective when [Fine Focus] is [On].)
Interlace Video Memory Select Interlace Video Setup

Chroma Level
Adjusts how saturated colours appear.

Hue

Adjusts the overall colour balance between red and green. (This is only effective when the DVD receiver is connected using the VIDEO OUT or S-VIDEO OUT jacks.)

2 Use the cursor button (�) to select [Video Setup] and press ENTER. 3 Press DISPLAY.

Memory (Interlace Memory)
Programs the current settings.

5 Use the cursor buttons (2/3) to adjust the settings.
Adjust these while a disc is playing to see the effect of changes immediately.

DNR Sharpness Detail Chroma Delay Gamma Memory

off min min green Off

On

Off

max

1

max max red 23

6 Repeat steps 4 and 5 to make adjustments to other settings.
If you would like to save the settings in the DVD receiver�s memory, be sure to select either [1], [2], or [3] in the [Prog. Memory] or [Memory (Interlace Memory)] setting to establish which memory location to save the new settings in. Please note that if you select a location where settings have already been saved, the old settings will be replaced by the new ones.

4 Use the cursor buttons (5/�) to select the setting and use the cursor buttons (2/3) to adjust the settings.
Adjust these while a disc is playing to see the effect of changes immediately.

5 To memorize the setting, select Memory 1, 2, 3, then press ENTER.
The previous setting will be erased.

Prog. Memory Move
ENTER

Off Select

1

2

3 Check

DISPLAY

7 When you are finished making adjustments, press ENTER to establish the new settings.
Tip
Progressive scan video has a greater scanning line density than standard interlace video. Graininess is minimized and you can enjoy a soft picture even with a big screen. *1 Progressive-scan compatible TVs also have on board progressive circuits. If you prefer, choose �Interlace� in this unit�s setup screen to view progressive-scan video adjusted by the TV�s on board circuits. If the TV is incompatible with this unit�s progressive output, picture disturbance occurs. For this type of problem, switch this unit�s output to Interlace. *1 When using a progresive-scan compatible TV.

73