Actually, I was looking for this information for 3 years!...now thanks to you, the manual is on my hands and of great help, cause I understand now where I was doing wrong connections and wires...excellent, I'll be back to you if in need, thank you.
This manual covers the main equipment features only. While it also includes the procedure for saving and loading from the now long obsolete memory cards it does not mention the how to operate with the optional floppy drive interface so I am still at a loss about how to use this! Note that there is a separate manual covering the MIDI interface and programming via the keyboard, not included in this download. You will also need to get hold of this if you want to use the MIDI interface properly. Basically there is little difference between this manual and the free to download manual for the similar PR60 model.
Good list of manuals. I found a very rare one and easily get. Should be promptly to download, as we must to wait hours even after confirmed payment.
Text excerpt from page 14 (click to view)
Installing the hood to the wall
It is possible to fix the hood in position, if necessary, by only attaching it to the rear wall. Proceed as follows: 1. Drill the four holes on the wall as indicated (Fig. 11). 2. Insert the four rawl plugs supplied into these holes. 3. Screw the two mountings hooks into the top two rawl plugs (Fig. 12). 4. Dismount the spacer M (Fig. 12) from the body of the hood by unscrewing completely the two spacer fixing screws O and washers. 5. Fix the base spacer M to the wall (Fig. 12) with the two screws R 5x45 provided (Fig. 11) using either the long or the short arm, depending on the depht of the side cupboards. Do not tighten the screws fully. 6. Fix the hood to the wall by means of the two hooks P previously mounted, but first move the upper brackets S (Fig. 11) so that the front panel of the hood, once mounted, will be in line with the front edge of the cupboard doors. The two upper brackets S, located at the top rear edge of the hood may be slid backwards and forwards by loosening its fixing screws T adjacent to them on the upper hood surface (Fig. 11). 7. Check that the hood is at the right height. Minor height adjustments may be made with the screws U embodied in the brackets (see Fig. 11). 8. Tighten the two wall fixing screws R, through the two access holes N provided on the inside of the hood (Fig. 12) then fix the lower sliding frame to the hood with two screws O and washers previously unscrewed (item 4).
