|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
Good service manual,i saved from scrapping this deck,is now fully functional.Thanks.
 ;
Found this to be the manual included with the original packinging, was helpfull but did not give any detailed repair instructions.
;
Complete service manual, was very helpful in repairing this tapedeck.Thanks.
;
The service manual was a copy of the original from Wirlpool. The quality was good, all neccecary information was available including the service-codenumbers, so I could order the right part to be replaced for repair.
Downloding was no probem after the payment.
Thanks for the service!
;
Good,readable manual. I found other manuals that were not readable when it came to part ID, but the one downloaded from owner-manual.com was better than expected. I will do buisness with owner-manual.com again.
2-1-1. Attachment/Removal of the DSBK-210
Attaching 1. Loosen the three screws, and slide the top cover of the DSR-2000/2000P away from the top retainer and blank panel. 2. Loosen the screw, then raise the board retainer and pull it out from the board retainer guide.
B4 x 6 Fixing screws (with stopper)
4. Pass the harness through the opening in which the connector panel fits and connect it to the two connectors of the connector panel ; then fasten the connector panel to the DSR-2000/2000P with the screw.
Harness
Connector panel Screw B3 x 6 Board retainer B3 x 6 (with stopper) Board retainer guides Blank panel Top retainer DIF-109B board
5. Connect the harness to connectors CN200 and CN201 on the DIF-109B board on the IF-821 board. (Both connectors output the same signals.)
CN200, CN201
IF-821 board
3. Remove the screw and remove the blank panel.
Blank panel Screw B3 x 6
2-2
DSBK-210
|
|
|
> |
|
