|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
Great quality manual, fast service, excellent seller... Thanks !!!
;
Great manual and fast service. Download was possible after a few hours.
;
thanks a lot.
without the service manual my handycam was going to the trash.
good job, go on.
bye
 ;
This service manual is a good copy of the original, complete and fully readable. It is really useful to repair my Tv set following its clear instructions.
;
Excellent quality. Easy process to download. No issues or problems at all - was exactly what I was looking for and needed. Great service.
DSC-P51/P51M
1-1-4. Precautions 1. Setting the Switch Unless otherwise specified, set the switches as follows and perform adjustments. 1. Mode Dial .......................................... CAMERA 2. ZOOM switch (PK-062 board S252, S254) .............. WIDE end 3. EV (Menu display) ............................ 0EV 4. DSIPLAY/LCD ON/OFF button (PK-062 board S256) ......................... OSD OFF 5. WB (WHITE BALANCE) (Menu display) ................................... AUTO 6. P.EFFECT (Menu display) ................ OFF 7. VIDEO OUT (SET UP setting) ......... NTSC
Yellow Cyan Green White Magenta
2. Order of Adjustments Basically carry out adjustments in the order given. Color bar chart (Color reproduction adjustment frame)
H C
Blue
Red
Electronic beam scanning frame
C=D
D
Magenta Red Blue Yellow Cyan
CRT picture frame
V AB A=B BA Enlargement
Fig. b (monitor TV picture)
Green
Difference in level
Adjust the camera zoom and direction to obtain the output waveform shown in Fig a and the monitor TV display shown in Fig. b.
B
A
Fig. 5-1-7
3. Subjects 1) Color bar chart (Standard picture frame). When performing adjustments using the color bar chart, adjust the picture frame as shown in Fig. 5-1-7. (Standard picture frame) 2) Clear chart (Standard picture frame) Remove the color bar chart from the pattern box and insert a clear chart in its place. (Do not perform zoom operations during this time) 3) Chart for flange back adjustment Join together a piece of white A0 size paper (1189mm � 841 mm) and a piece of black paper to make the chart shown in Fig. 5-1-8. Note: Use a non-reflecting and non-glazing vellum paper. The size must be A0 or larger and the joint between the white and black paper must not have any undulations.
White
White 841 mm Black
1189 mm
Fig. 5-1-8
5-6
|
|
|
> |
|
