|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
I needed the manual immediately and I got it immediately. I couldn't find this manual anywhere else on the net. The site was easy to traverse, and the price was very reasonable. I'll definitely be back for any future needs.
 ;
I received a good service manual, with good resolution. Improve the instructions for the purchase because they are not well understood.
For the rest, so good.
Thanks Angel.
;
Very good documentation for the Grundig 2077 model (as well as similar 800/900/1000 series radios). The first two pages are a summary of reception specifications and output capability. The third page is the tuner dial indicator and dial cord routing diagram. the final ~5 pages are the schematics for the various models (including 2077). The scan quality of the schematics are good, adn can be easily read if zoomed in. The documents are in German, not English as stated. It would have been nice to have the tuning sequence and settings, and some trouble shooting materials... or component and wiring map.
;
Perfect like it was descriped, Perfect like it was descriped
;
Very good detail, all pages clear, exactly what I needed
DSC-P9
1-5.
LCD SYSTEM ADJUSTMENTS
Before perform the camera system adjustments, check that the specified values of �VIDEO SYSTEM ADJUSTMENTS� are satisfied. Note 1: Taken an extreme care not to destroy the liquid crystal display module by static electricity when replacing it. Note 2: Set the LCD BRIGHTENSS (SET UP setting) to the NORMAL.
[Adjusting connector] Most of the measuring points for adjusting the LCD system are concentrated in CN706 of the SY-77 board. Connect the Measuring Instruments via the CPC-9 jig (J-6082393-C). The following table shows the Pin No. and signal name of CN 903. Pin No. 1 2 3 4 5 6 7 8 9 Signal Name N. C. N. C. N. C. REG_GND CPC_IN N. C. HSY PANEL_COM VG Pin No. 10 11 12 13 14 15 16 17 18 Signal Name HI UNREG LANC IN LANC OUT N. C. N. C. N. C. N. C. N. C. N. C.
CPC-9 jig (J-6082-393-C) (Note 1, 2) 18 CPC cover 1 SY-77 board CN706
Note 1: Don�t use the 12 pin flexible board of CPC-9 jig. It causes damage to the unit. Note 2: The old CPC-9 jig (Parts code: J-6082-393-B) cannot be used, because it cannot operate the adjusting remote commander.
Fig. 5-1-18
5-33
 $4.99 DSCP9 SONY
Owner's Manual Complete owner's manual in digital format. The manual will be available for download as PDF file aft…
|
|
|
> |
|
