|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
Detailed schematic diagram, manual for professionals
;
Good service manual,exploded view,adjusment and test point locations,head alignment,mechanical checks and adjusments,all perfect.
;
Block diagram,play rec block diagram,adjusments, it's a very good well done repair manual.
;
Very clear copy of the philips service manual. Fast delivery. Thank you very much
;
Excellent manual, detailed, very useful! Exactly what I needed, I'd recommend it to all who need it. Although images are scanned easily readable and explicit. A valuable tool product at a price more than modest, take it with confidence and you will not regret it!
2. DISASSEMBLY
NOTE FOR REPAIR
� Make sure that the flat cable and flexible board are not cracked of bent at the terminal. Do not insert the cable insufficiently nor crookedly. � When remove a connector, don�t pull at wire of connector. It is possible that a wire is snapped. � When installing a connector, don�t press down at wire of connector. It is possible that a wire is snapped. � Do not apply excessive load to the gilded flexible board.
Cut and remove the part of gilt which comes off at the point. (Be careful or some pieces of gilt may be left inside)
DISCHARGING OF THE ST-171 BOARD�S CHARGING CAPACITORS (C901, C902)
The charging capacitors (C901, C902) of the ST-171 board is charged up to the maximum 315 V potential. There is a danger of electric shock by this high voltage when the capacitor is handled by hand. The electric shock is caused by the charged voltage which is kept without discharging when the main power of the unit is simply turned off. Therefore, the remaining voltage must be discharged as described below.
Preparing the Short Jig
To preparing the short jig, a small clip is attached to each end of a resistor of 1 k� /1 W (1-215-869-11). Wrap insulating tape fully around the leads of the resistor to prevent electrical shock.
1 k�/1 W
Wrap insulating tape.
Note: High-voltage cautions Discharging the Capacitor Short-circuit between the two points with the short jig about 10 seconds. To avoid the spark with the metal plate, wrap the short jig with the insulation tape. C902
C901
R:1 k�/1 W (Part code: 1-215-869-11)
DSC-T200_L2 2-1
|
|
|
> |
|
