|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
got exactly what i ordered in a very timely manner. will use again for other manuals
 ;
I'm happy. Good quality. Very helped me with my work..............................
;
This is the second Manual I have ordered from owner-manuals, I give it five stars because it is exactly what I expected given the age of the equipment. So the contents look a bit aged and the pictures a bit grainy, it fulfills my needs and I am glad I can still get hold of them.
;
thank u so much for this manual that was so cheap that i thought it was a scam but i gambled anyway because it was too good of a deal to pass up and behold,the manual has everything and details of everything even the screws and im still amazed and very happy with my manual .so take my word and jump on it before they realize how cheap they selling thier manuals..thank you so much for taking time to read my thoughts
;
I do not have very much to say.
The price is quite covenient, delivery was better as promised (about 12 ours, against the specified 24 hours if I remember well), and the quality of the PDF is more than acceptable.
The Service Manual of Sansui R30 itself is also satisfactory: good graphic for schematics and layouts, simple and well structured.
Giovanni Bianchi
2-1-10. IRIS RING REMOVAL/INSTALLATION
Removal Rotate the iris ring clockwise, and remove it at the stop position (iris-in end). (Fig. 10-1) At this time, do not rotate the iris joint gear of the Aperture Unit. Installation 1. With the Aperture Unit set in the charge position (see "2-1-12. Aperture Unit Charge Position Setting" ), install it on the front frame set. *The Aperture Unit has been set in the charge position, if it is not removed. However, the iris ring must be in the removed state (where the iris joint gear is not rotated). 2. Install the iris ring with it's a punch mark aligned with a line that connects the iris joint gear shaft and the optical axis center. (Fig. 10-1)
Optical Axis Center
Iris Joint Gear Shaft Iris Ring
Punch Mark
Fig. 10-1
2-1-11. APERTURE UNIT INSTALLATION
*The Aperture Unit is supplied by being set in the charge position (initial position), but if this position is disordered when the Aperture Unit is removed, or if the charge position is to be set again, perform as follows. *Refer to �2-1-12. Aperture Unit Charge Position Setting� for the confirm method at the charge position.
2-1-12. APERTURE UNIT CHARGE POSITION SETTING
1. Check that the Aperture Unit is in a free state. 2. After confirming that the Aperture Unit is in a free state, rotate the gear by 3 turns. 3. After rotating the gear by 3 turns, set the Aperture Unit where the holes in the gear and the Aperture Unit coincide. This position is the charge position. *Refer to �2-1-13. Aperture Unit Free Position Setting� for the setting and the confirm method at the free position.
DSLR-A100_L2 2-21
|
|
|
> |
|
