|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
Thank´s for your help, I already recived these manual from you
;
Thank you for your manual It has the basic things to and i use the Oszi for Longer Time.
THX
;
Actually, I was looking for this information for 3 years!...now thanks to you, the manual is on my hands and of great help, cause I understand now where I was doing wrong connections and wires...excellent, I'll be back to you if in need, thank you.
 ;
This manual covers the main equipment features only. While it also includes the procedure for saving and loading from the now long obsolete memory cards it does not mention the how to operate with the optional floppy drive interface so I am still at a loss about how to use this! Note that there is a separate manual covering the MIDI interface and programming via the keyboard, not included in this download. You will also need to get hold of this if you want to use the MIDI interface properly. Basically there is little difference between this manual and the free to download manual for the similar PR60 model.
;
Good list of manuals. I found a very rare one and easily get. Should be promptly to download, as we must to wait hours even after confirmed payment.
ST AUDIO DSP2000 C-Port What is displayed by External Links? After we have performed the needed one-time steps to 'tell' the DSP24 driver what hardware options we have installed, we can check what else we can do with the software. The software is divided into three main sections (yes, from right to left): 1. All the available inputs are displayed on the right side of the window. You can connect them virtually on screen when needed. 2. The section in the middle symbolizes the I/O interface on the DSP24 card. The virtual connectors on the right side (gray) are representing the input channels of the card, the connectors on the left side (white) are the available sources for the outputs. 3. The output channels of the card are displayed on the left side of the window. The digital output (S/PDIF Out) and also the 8 channels of the external boxes are displayed under with the DAC headline (Digital to Analog Converter) The virtual cables on screen show you the signal routing for all inputs and all inputs. The input cables on the right side can be removed and added as needed. The virtual cables for the outputs (which mainly control the monitoring) cannot be removed but replaced by other connections. Because of that, the connections are displayed as straight lines. The five gray virtual connectors in the middle section are corresponding to the MME wave devices (and the ASIO-driver) you are using inside your application. The first one (S/PDIF In) corresponds to the wave device ADSP24 S/PDIF Input (n) (where n is the card number when multiple DSP24 cards are installed) or to channel 9/10 of the ASIO driver. The others (Input x,y) correspond to the wave devices ADSP24 Ext. (n) Input x/y or to channels x/y of the ASIO driver (where x+y are the numbers of the channels). This means for example: if you record using ADSP24 Ext. (1) Input 5/6, you will get the signal from the yellow virtual cable which would be the input signal from the inputs number 5 and 6 of the ADC&DAC2000 box. On the left side of the middle section, the available output sources are listed with white connectors. You can see:
- 23 -
|
|
|
> |
|
