|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
This is a great manual. It was easy to read and very accurate. The size of the manual is small so email is no problem. I highly recommend it. The manual is very hard to find other than this website.
;
Manual was complete and available promptly, since I had lost my original manual. Very good response.
;
Whilst this is a photo copy, and some of the pages are a little askew, it was all readable and intact. A real bonus finding an old manual for a classic piece of kit that no other site had.
Great stuff.
;
excellent quality, contains circuits and scan quality, 110 pages
;
It was easy done, and I got exactly what I was looking for.
Before Using the DVD receiver
Installing the Batteries Using the Remote Controller
To use the remote controller, point it at the DVD receiver�s remote control sensor, as shown below.
Remote control sensor DVD receiver
1
To open the battery compartment, press the small hollow and slide off the cover.
Approx. 16 ft. (5 m)
2
Insert the two supplied batteries (AA/R6) in accordance with the polarity diagram inside the battery compartment.
3
Put the cover onto the remote controller and slide it shut.
Notes: � The remote controller may not work reliably if the DVD receiver is subjected to bright light, such as direct sunlight or inverter-type fluorescent lights. Keep this in mind when installing the DVD receiver. � If another remote controller of the same type is used in the same room, or the DVD receiver is installed close to equipment that uses infrared rays, the remote controller may not work reliably. � Don�t put anything, such as a book, on the remote controller, because the buttons may be pressed inadvertently, thereby draining the batteries. � The remote controller may not work reliably if the DVD receiver is installed in a rack behind colored glass doors. Keep this in mind when installing the DVD receiver. � The remote controller will not work if there�s an obstacle between it and the DVD receiver�s remote control sensor.
Notes: � If the remote controller doesn�t work reliably, try replacing both batteries. � Don�t mix new and old batteries, or different types of batteries. � If you intend not to use the remote controller for a long time, remove the batteries to prevent possible leakage and corrosion. � Flat batteries should be removed as soon as possible to prevent possible leakage and corrosion.
11
|
|
|
> |
|
