|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
Yes thank you i got the file i was after. There was a slight problem in my communication but it all worked out well.
A job well done.
 ;
Great manual...really saved me. The only problem is that I thought I would be able to download it directly when I paid for it but never received the download instructions until the next morning. The board trace pages were somewhat light also: really need to turn up the contrast on the printer before printing them. The schematic page was great; very clear! Well worth the money.
;
I've been in the electronic business for a long time. I used to buy Sam's Photofact for my needs which intailed having to go to the store and paying about $20 for a package of 3 different units so I was forced to buy more than I needed just to get one.
Owner manual is just at your keyboard and the information is almost instantansouly and the cost is very reasonable. Easy to print out if needed or simply read off of the screen. The larger the screen the better for obvious reasons.
;
Very good manual, at a very good price. Received in a timely manner
;
Only thу cover has poor quality, internal material has excellent quality - exactly what I needed
Thanks!
Alignment Instructions
1. AFT
1) Set a signal Generator with - RF FREQUENCY = 38.9MHz, 34.2MHz (L� ) - RF OUTPUT LEVEL = 80 + 5dBuV _ - System = PAL / SECAM - B/G, D/K, I, H NTSC - 3.58/4.43 2) Connect the Signal Generator RF Output to P101 (Tuner IF Output). There must be no signal input to the tuner. 3) Press the � AFT�KEY in Service Mode and wait until the � Please wait�disappear on the TV screen.
2. AGC
1) Set a pattern Generator with - RF LEVEL = 60dBuV - 100% FULL COLOR BAR 2) Connect the Pattern Genetator RF Output to Tuner RF Input. 3) Press the � AGC�KEY in Service Mode and wait until the � Please wait�disappear on the TV screen.
3. SCREEN
1) Receive the Retma pattern and heat run over 15minutes. 2) On the normal mode1 adjust the screen volume that the horizontal line appears on the screen after pushing the � SCREEN� KEY on the SVC Mode. 3) Adjust the screen volume that the horizontal lines reach the cut-off point.
4. WHITE BALANCE
1) Set the TV to NOR 1 mode. 2) Adjust the R,G,B UP/DOWN KEY of the color which appears abnormally on the screen to obtain WHITE BALANCE.
5. FOCUS
1) Apply a RETMA PATTERN signal. 2) Adjust the FOCUS VOLUME on FBT to obtain optimal resolution.
6. GEOMETRY 6.1 VERTICAL CENTER
1) Set the TV to NOR 1 mode. 2) Pressing the V-SIZE UP/DOWN KEY, the lower half of the screen is blanked. 3) Adjust the border line of blanked picture coincident with the mechanical center marks of the CRT using the V-CENTER UP/DOWN KEY.
6.2 VERTICAL SIZE
* The VERTICAL CENTER adjustment has to be done in advance. 1) Apply a RETMA PATTERN signal. 2) Set the TV to NOR 1 mode. 3) Adjust the upper part of the picture with the V-SIZE UP/DOWN keys.
|
|
|
> |
|
