|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
I searched EVERYWHERE looking for the manual/s on this "extinct" amp. Owner-Manuals.com made it available and for nearly nothing. Thanx to them, I can decipher the unknown cables and sort them out. Thanx, Owner-Manuals.com!!
;
Yes thank you i got the file i was after. There was a slight problem in my communication but it all worked out well.
A job well done.
 ;
Great manual...really saved me. The only problem is that I thought I would be able to download it directly when I paid for it but never received the download instructions until the next morning. The board trace pages were somewhat light also: really need to turn up the contrast on the printer before printing them. The schematic page was great; very clear! Well worth the money.
;
I've been in the electronic business for a long time. I used to buy Sam's Photofact for my needs which intailed having to go to the store and paying about $20 for a package of 3 different units so I was forced to buy more than I needed just to get one.
Owner manual is just at your keyboard and the information is almost instantansouly and the cost is very reasonable. Easy to print out if needed or simply read off of the screen. The larger the screen the better for obvious reasons.
;
Very good manual, at a very good price. Received in a timely manner
APPENDIX IC DESCRIPTION
13
PIN NAME CW OUT
FUNCTION An output terminal for the continuous chroma sub-carrier frequency wave, with an amplitude of 0.7Vp-p (typ). Also the dc level shows chroma killer status, with a level of 3.5V for B/W and 1.5V for Color.
INTERFACE
14
RGB VCC(9V)
15
YS/YM SW /Spot killer
A Vcc terminal for RGB block, PIF det. Output and sound output circuit. Supply 9V. A terminal for switching of EXT RGB Mode and fast Half tone.
-
16 17 18
EXT.R IN EXT.G IN EXT.B IN
Input terminals for EXT RGB signals. The signals are clamped by capacitors, therefore the input impedance should be low, 100 ohms or less is recommended. For this input, the brightness and RGB contrast is adjustable, the ABL/ACL limits the output level. This ABL/ACL may be turned On and OFF. OFF : for small area like OSD ON : for large area like TELETEXT (input level 0.7Vp-p/100IRE) The GND terminal for Y/C circuit. Terminals for R/G/B signal output. Connect resistances to GND, for the current source if the slew rate is not enough. Due to the source current limitation, the resistances should be 2.0 or more.
19 20 21 22
Y/C GND R OUT G OUT B OUT
-
-6-
|
|
|
> |
|
