|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
have download a number of manuals todate , most are excellant, one or two sometimes a little difficult to read but a least avaialable, great site .
Brad.
;
Excellent had everything I wanted, very happy with purchase
 ;
This service is relatively cheap, document is fast available, schematic is readable.
Thanks.
;
So far I´m a satisfied customer. I have only downloaded "TECHNICS SX-KN470 Service Manual" maybe I will use it later.
Best regards
Peter
;
Good manual. It is complete and of high quality, both text and graphics. The schematics are with the original big size, so it can be viewed or printed without any loss of resulution and sharpness.
6. GEOMETRY 6.1 VERTICAL CENTER
1) Set the TV to � NORMAL I�mode. 2) Enter the service mode. 3) Locate the cusor at � V.CENTER�then press � VOL +� or � VOL -�keys to adjust the center line with the mechanical center marks of the CRT.
6.2 VERTICAL SIZE
* The VERTICAL CENTER adjustment has to be done in advance. 1) Receive the Retma pattern. 2) Set the TV to � NORMAL I�mode. 3) Enter the service mode. 4) Locate the cursor at � V.SIZE�then press � VOL +� or � VOL -�keys to adjust the upper part of the picture.
6.3 HORIZONTAL CENTER
1) Apply a RETMA PATTERN signal. 2) Set the TV to � NORMAL I�mode. 3) Enter the service mode. 4) Locate the cursor at � H.CENTER�then press � VOL +� or � VOL -�keys to adjust the picture centering.
if EEPROM(I702) has been changed; - Option data has to be change and - all alignment function has to be readjusted * The initial state of adjustment are as follows; - V-Center, V-Size, H-Center, R, G, B, AFT = Center ( - AGC = * Service Remocon )
|
|
|
> |
|
