|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
This is a great site. I placed my order and by the next am it was available for download. Had some problems with some missing copy on some pages. Once I brought the error to the OMC's attention, the issue was resolved. I'll come back again.
 ;
Mi spiace per non poter scrivere in inglese... ma sono veramente soddisfatto del servizio offerto. Grazie..!!
;
The quality of this manual is good. It has all schematics and setup information for both the MDS-B3 and the MDS-B4. The scan quality is quite good, all pages are readable, This service manual also contains scans of the operating instructions from the User manual.
;
Quick site processing. A complete and very useful manual with all details. Thank you!
;
Das Service Manual war von der ersten bis zur letzten Seite sehr informativ und hilfreich. Die Darstellung aller Teile war klar und der Text gut lesbar.
Vielen Dank, das war nicht der letzte Download bei ownner-manuals.com.
DTR-5.5 ADJUSTMENT AND CONFIRMATION PROCEDURES
1.Idling current adjustment
Before Idling adjustment, turn the trimming resistors R6040 to R6045 counter-clockwise fully. Connect the DC voltmeter to sockets P6080 to P6086. After turn POWER to ON, adjust the trimming resistors R6040, R6041 and R6042 so that the reading of voltmeter becomes 1.25mV. (Front and center channels) Adjust the trimming resistors R6043, R6044,R6045 and R6046 so that the reading of voltmeter becomes 0.75 mV. (Surround and surround back channels) After adjustment, attach the top cover. Confirm the voltage of points above after about five minutes. Front and center channels When less than 5.0 mV, readjust the resistors above so that the voltage becomes 5.0 mV. When 5.0 mV to 6.0 mV, it is not necessary to adjust. When more than 6.0 mV, readjust the resistors above so that the voltage becomes 6.0 mV. Surround and surround back channels When less than 3.5 mV, readjust the resistors above so that the voltage becomes 3.5 mV. When 3.5 mV to 4.5 mV, it is not necessary to adjust. When more than 4.5 mV, readjust the resistors above so that the voltage becomes 4.5 mV. Note: No load and No signal
IDID+ ID+ ID-
COM BIAS R6040 P6080 BIAS R6041 P6081 BIAS R6042 P6082 ID+ IDBIAS R6043 P6083 BIAS ID+ IDR6044 ID+ IDSL P6003B P6084 P6004B ID+ IDTH2 P6301 TH1
L
P6000B
R
P6001B
C
P6002B
SR
NAAF-8397
NAAF-8391
BIAS R6045 SBL P6085 BIAS R6046 P6086 SBR ID+ ID-
|
|
|
> |
|
