|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
This is an excellent handbook. We had no information on the appliance until we obtained this and are now able to use the appliance to its full potential. Strongly recommended.
;
Very happy to find this from owners-manual.com and the enclosed spec sheet as well.
Not longer available from Sony.
;
The Owner's manual was very helpful. The WEGA is about 35 years old and needed repair.
Your Website is pretty good und easily to handle.
Thank You
Carl-W. Lohmann
;
Perfect. Very good service and very good scanning quality. All sheets are very legible. Thank's
;
My first manual from Owner-Manuals.com but not the last! I am very satisfied with the easy ordering and promt delivery of a manual I did not find anywhere else.
Operating Continued
Instructions
Startingyourdishwasher
1. Select a drying option. (Use the Air Dry Option for Rinse 8 Hold Cycle.) 2. Turn Cycle Control Knob clockwise to point to a desired cycle. You will feel a definite stop at each cycle mark. The dishwasher will automatically start that cycle. NOTE: If the door is start and stop as the mark. This is normal washer If you prefer, door unlatched. latched, you will hear cycles knob passes each cycle and will not hurt the dishyou can set cycles with the
Toadda dishafterstarting
1. To be sure the added item is washed and rinsed, make sure the Cycle Control Knob has not passed LIGHT WASH. 2. Lift up on the door latch to unlatch door and stop the cycle. 3. Open the door and add the dish. 4. Close the door. Do not latch it. Wait 30 seconds for air in the dishwasher to warm up. This helps reduce the amount of moisture that can come from the vent when restarting the cycle. 5. Press door in to latch it. The dishwasher will start where it stopped.
Changing cyclesetting a
You can change a setting anytime during any cycle. 1. Lift up on the door latch to unlatch the door and stop the cycle. 2. Turn the Cycle Control Knob clockwise to the cycle you want. 3. Be sure the detergent dispensers are filled properly for the new cycle. When changing dial from LIGHT WASH to NORMAL WASH setting, detergent is released. Reload covered section of dispenser before starting Normal Wash Cycle. 4. Close and latch the door. The dishwasher will automatically start the new cycle.
|
|
|
> |
|
