|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
Very happy to find this from owners-manual.com and the enclosed spec sheet as well.
Not longer available from Sony.
;
The Owner's manual was very helpful. The WEGA is about 35 years old and needed repair.
Your Website is pretty good und easily to handle.
Thank You
Carl-W. Lohmann
;
Perfect. Very good service and very good scanning quality. All sheets are very legible. Thank's
;
My first manual from Owner-Manuals.com but not the last! I am very satisfied with the easy ordering and promt delivery of a manual I did not find anywhere else.
 ;
This manual is very helpfull to use the Power Supply. All technical information has been available.
For service use the circuit diagrams are very good.
Thanks .
Before starting your dishwasher
1. Spin the Upper Spray Arm to make sure nothing will stop it from turning freely. 2. Close and latch the door. 3. Run hot water at sink nearest dishwasher until it is hot. Turn it off. (If youirs is a portable dishwasher, see page 14 for connecting instructions.)
Starting
POTS &PANS
your dishwasher
Cycle...
Clean Selector Buttons
HEAVY WASH Cycle...
1. Make sure Cycle Control Knob points to dot marked HEAVY WASH. 2. Push HEAVY WASH button. 3. Push button for option desired. 4. Wlthout turning it, pull out the Cycle Control Knob to start the cycle.
1. Make sure Cycle Control Knob points to dot marked POTS &PANS. 2. Push POTS & PANS Clean Selector Button. 3. Push button for option desired. 4. Without turning it, pull out the Cycle Control Knob to start the cycle.
RINSE & HOLD Cycle...
Select AIR DRY Option only. Push NORMAL WASH Button. Unlatch door and open slightly. Pull Cycle Control Knob out. Turn Control Knob Clockwise to dot marked RINSE & HOLD. 6. Close and latch the door to start the cycle. 1. 2. 3. 4. 5.
NORMAL WASH Cycle...
1. Turn Cycle Control Knob clockwise until It stops at dot marked NORMAL WASH. 2. Push NORMAL WASH button. 3. Push button for optlon deslred. 4. Without turning It, pull out the Cycle Control Knob to start the cycle.
Changing
a setting
during
YOU can change a setting anytime any cycle. 1. Unlatch the door to stop the cycle.
2. With the Cycle Control Knob pulled out, turn clockwise to the cycle you want. 3. Be sure the detergent dispensers are filled properly for the new cycle. 4. Latch the door to start the cycle. 4. Close the door. Do not latch It. Wait 30 seconds for air in the dishwasher to warm up. This helps reduce the amount of moisture that can come from the vent when restartrng the cycle. 5. Latch the door. The dishwasher will start from where it stopped.
To add a dish after starting
1. To be sure the added item is washed and rinsed, make sure the Cycle Control Knob has not passed NORMAL WASH. 2. Unlatch the doorto stop the cycle, but don�t open it until the spray arms stop spinning. 3. Open the door and add the dish.
HI-TEMP
WASHING
is selected,
Option
water for the rinsing action in those parts of the cycle will be longer if the water is heated. HI-TEMP washing is automatic in POTS & PANS.
When this option
main wash and the final rinse is heated (except In RINSE & HOLD) to 145°F (63°C). Washing and
|
|
|
> |
|
