|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
the manual was very helpful thank you very much no one else was able to help me thanx
;
This is an excellent handbook. We had no information on the appliance until we obtained this and are now able to use the appliance to its full potential. Strongly recommended.
;
Very happy to find this from owners-manual.com and the enclosed spec sheet as well.
Not longer available from Sony.
;
The Owner's manual was very helpful. The WEGA is about 35 years old and needed repair.
Your Website is pretty good und easily to handle.
Thank You
Carl-W. Lohmann
;
Perfect. Very good service and very good scanning quality. All sheets are very legible. Thank's
Before starting your dishwasher 1. Read �Important Safety Instructions� on page 2 before starting your dishwasher. 2. Spin the Upper Spray Arm to make sure nothing will stop it from turning freely. 3. Push door firmly when closing and it will automatically latch. 4. Run hot water at sink nearest dishwasher until it is hot. Turn it off.
CYCLE SELECTOR BUTTONS OPTION SELECTOR BUTTONS - POTS & PANS and HEAVY WASH Cycles share the same spot on the dial, CHINA CRYSTAL and LOW ENERGY WASH Cycles also share a spot on the dial. The Cycle Selector Button determines which cycle operates. The dishwasher will automatically start the selected cycle. NOTE: Options may be changed or cancelled by pushing the Option Selector Button(s) again.
Starting your dishwasher
1. Push a Cycle Selector Button for the desired cycle. 2. Push Option Selector Button for desired option or options. (Use AIR DRY for RINSE & HOLD Cycle.] 3. Turn Cycle Control Knob clockwise to point to a desired cycle. You will feel a definite stop at each cycle mark.
Selecting
a cycle
POTS & PANS Cycle
Maximum cleaning for cookedor baked-on foods. Timer delays while the dishwasher automatically heats the water to 145°F (63°C) in both washes and the last rinse [marked �1. Cycle time will be about 11/2to 2 hours, depending on time needed to heat water.
HEAVY WASH Cycle
A double wash for heavily soiled loads. Cycle time is about 75 minutes.
NORMAL WASH Cycle
For normal, everyday soiled loads. (The Energy Guide Label data is based on this cycle.) Cycle time is about 65 minutes.
LOW ENERGY WASH Cycle
For pre-rinsed loads. Cycle minutes. or lightly soiled time is about 60
|
|
|
> |
|
