|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
very helpful, the information in these manuels are very detailed
;
Please tell us what you think and share your opinions with others. Be sure to focus your comments on the product. You will receive $2.00 of store credit for Your review.
;
Please tell us what you think and share your opinions with others. Be sure to focus your comments on the product. You will receive $2.00 of store credit for Your review.
;
Good copy and great customer service! There was some confusion with my order and it was resolved promptly!
;
Having bought a pre-owned Sony FM stereo tuner through eBay, it came without any manuals. It soon became clear that to get the best from this excellent tuner I needed a decent manual because much of the operation was not intuitive to a newboy to hi fi like me. I managed to download the official Sony multi-lingual manual from Owner-Manuals.com with no problem at all - a really quick and easy service. I'm very glad I did because I found out all the operations of the tuner and was then able to not only set it up quickly but also to get much more from it that poke-and-hope trialling would ever achieve. In my book $4.99 very well spent.
The WATER HEATING signal light
The WATER HEATING signal light comes on during the water heating portions of the Pots 8 Pans Cycle. The signal light will also come on during the water heating portion of other cycles when the Hi-Temp Option is selected. The WATER HEATING signal light will flash at the end of the cycle if the water did not heat to 140°F (60%). If you want to make sure the water gets heated to 140°F (SO�C), use the Hi-Temp Option (see page 10). When the signal light is on, water is being heated. The heating time is based on the temperature of the water supply as it enters the dishwasher. The cooler the water, the longer the heating time. The WATER HEATING signal light will go off when the water temperature reaches 140°F (SOOC).
The CLEAN signal light
The CLEAN signal light comes on at the end of a cvcle to show that the load IS clean. It will stay on until CANCEL/DRAIN or any other control pad is pressed. As an option, you can have the CLEAN light turn off the first time you open the door after a cycle is finished: 1. Press and hold the CYCLE pad until the CLEAN signal light starts flashing.
2. Release the pad. The CLEAN signal light will turn off. NOTE: A power failure will reset this feature. You will have to redo the above steps. To again have the signal light stay on when the door is opened: 1. Press and hold the CYCLE pad until the CLEAN signal light turns on.
C
2. Release the pad. The CLEAN signal light will turn off.
7
|
|
|
> |
|
