|
Who's Online
There currently are 6039 guests online.
|
Categories
|
Information
|
Featured Product
|
|
|
|
|
There are currently no product reviews.
;
Manual found fast and good quality, very helpfull service
;
8-17-12 Been using the sight for about 6 months. Fast Downloads and top quality
Manuels !
;
Everything was great, the manual, the response time, the simplicity of the order, and the
Price. The only thing that I could possible say on a negative note would be that the manual I ordered was more for a service tech. There were a lot of schematic diagrams that didn't help me solve the problem. However I would order again and recommend the web sight to others.
;
I'd been looking for this manual for awhile. Exactly what I needed - and at an excellant price. Thanks!
;
very complete. acceptable resolution. details are a little unclear. is a manual note 8.
CIRCUIT OPERATIONAL DESCRIPTION
4) SDRAM : HY57V660ET-7 (DV-000S/DV-00S/DV-200S/DV-300S/DV-400S/DV-70S) This sends and receives data with MPEG decoder and performs the video signal processing. Every video signal output from DVD player is once stored in SDRAM and then encoded in MPEG decoder and finally output into the analog signal. SDRAM applied to DVD module has the capacity of 6MBit(048576 x 6bit x Bank), sends and receives data with MPEG decoder by 6 bit. Description THE Hynix HY57V660E is a 6,777,26 bits CMOS Synchronous DRAM, ideally suited for the main memory and graphic appli-cations which require large memory density and high bandwidth. HY57V660E is organized as 2banks of 524,288x6. HY57V660E is offering fully synchronous operation referenced to a positive edge clock. All inputs and outputs are synchronizedwith the rising edge of the clock input. The data paths are internally pipelined to achieve very high bandwidth. All input and outputvoltage levels are compatible with LVTTL. Programmable options include the length of pipeline (Read latency of ,2 or 3), the number of consecutive read or write cycles initi-ated by a single control command (Burst length of ,2,4,8 or full page), and the burst count sequence(sequential or interleave). Aburst of read or write cycles in progress can be terminated by a burst terminate command or can be interrupted and replaced by anew burst read or write command on any cycle. (This pipeline design is not restricted by a `2N` rule.)
3
Sm(DAEWOO_1389C)060109.indd
13
2006-1-13
15:42:03
|
|
|
> |
|