|
There are currently no product reviews.
 ;
I must admit, I was very skeptical... $4.99 for a 74 page service manual. I've seen some very poorly scanned manuals on the Internet, but this one is VERY good quality! Even when zooming into 500%. Great Deal!
;
Very good detail, Quick service response. A useful service manual with all details. I recomend this service.
;
As Always you can find here manuals even of difficult TV scheme which are scan in almost perfect way.clear and fast!!!!!
Great work thanks!
;
Incredibly clear!!!! Well done, complete and wonderful. It could not better than this!!!!
 ;
Thank You for fast delivery for the sheme.
Everything allright.
Thanks & best regards Franz
5
6
7
8
7.1.10 DISASSEMBLY
Note: For performing the diagnosis shown below, the following jig cables for service are required: � GGD1330 �2
A
Diagnosis of the PCBs
Procedures ; SCRB Assy : ¥ � ø � � JCKB Assy : ¥ � ø � � � [ DVDM Assy : ¥ � ø � �
1 Bonnet and Tray Panel
1 2 3 4 5 6
Remove the Bonnet by removing the five screws. Press the power. STANDBY/ON button to turn on the
B
26
Press the 0 button to open the tray. Remove the tray panel. Press the 0 button to close the tray. Press the power. STANDBY/ON button to turn off the
4 3 5
Tray Panel Tray
C
35
How to open the Tray when the power cannot be on
Insert a screwdriver (small) into the slit located at the bottom of the unit, and slide the projection of the drive gear in the loading mecha. assy in the direction of the arrow, as indicated in the photo. If the tray pops out a little, fully pull it out by a hand.
D
Screwdriver (small) Projection
Slit Drive Gear Loading Mecha.Assy
E
Tray open
Screwdriver (small)
F
DV-565A-S
5 6 7 8
69
|
