|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
Excellent manual. In addition to the information I needed was a complete description of both electronic and mechanical devices.
Excellent site.
Thank you very much.
 ;
very good and complete manual , it is in english and german is perfect for repair.
;
This manual is complete and of high quality. I am very pleased with the purchase.
;
Another excellent buy! A fully readable PDF archive. Good prints!!
;
It is wonderful done!!! a great job in scanning the manual. Superior quality in all the electric scheme. Very understandable and net!!! Thank you!
DV-626D
7.1.2 TROUBLE SHOOTING
� No Power ON � FL is not turned ON � FL indication is unusual
START
Power ON
� Blow out fuse of the primary side � Blow out micro-fuse on the POWER SUPPLY Assy. (Check the each voltage.) (P611, P211, R711) � FL controller IC (IC101) on the FLKY Assy is damaged.
Turn on the power again after 2 - 3 minutes. � Check the following connections : POWER SUPPLY Assy - DVDM Assy DVDM Assy - FLKY Assy FLKY Assy - PWSB Assy � Check each voltage (EV+5V, SW+5V, SW+3.3V, +6V and +12V) (If above voltage are not supplied, check the micro-fuse.)
Is FL turn on ? Yes
No
Is the indication of FL normal ? Yes
No FL indication is dark or flickers.
� Short or open the zenner diode on the POWER SUPPLY Assy. (D513) � Check the values of R118 - R120 on the FLKY Assy.
Indicates the error message
Refer to the section "7.1.3 ERROR CODE".
� Blow out micro-fuse on the POWER SUPPLY Assy. (R711)
Is tray open ? Yes
No
� Check the connection between LOSB Assy and DVDM Assy. (12P flexible cable) � Check the +6V power supply voltage (above micro fuse).
Do the video and sound come on ? Yes
No
Check the connection between JCKB Assy and DVDM Assy. A video isn't displayed. Check the connection between VQEB Assy and DVDM Assy. Refer to the section "7.1.3 ERROR CODE".
OK
Indicate the error message.
63
|
|
|
> |
|
