|
There are currently no product reviews.
 ;
Again a great job. I never been disilluted from them! Clear scheme, complete and very good for repairing!
;
Great manual just what I needed, great service as always, thanks.
;
Great quality complete service manual! complete parts list and drawings. Thanks!
;
Great quality complete service manual! complete parts list and drawings. Thanks!
;
Very good quality, prompt response. This website has reasonable prices and wide range of manuals that are hard to find.
5
6
7
8
7.1.10 DISASSEMBLY
Note: For performing the diagnosis shown below, the following jig cables for service are required: � GGD1330 �2
A
Diagnosis of the PCBs
Procedures ; JCKB Assy : ¥ � ø � � DVDM Assy : ¥ � ø � [
1 Bonnet and Tray Panel
1 2 3 4 5 6
Remove the Bonnet by removing the five screws. Press the STANDBY/ON button to turn on the power. Press the 0 button to open the tray. Remove the tray panel. Press the 0 button to close the tray. Press the power. STANDBY/ON button to turn off the
26
B
4 3 5
Tray Panel Tray
35
C
How to open the Tray when the power cannot be on
Insert a screwdriver (small) into the slit located at the bottom of the unit, and slide the projection of the drive gear in the loading mecha. assy in the direction of the arrow, as indicated in the photo. If the tray pops out a little, fully pull it out by a hand.
D
Screwdriver (small) Projection
Slit Drive Gear Loading Mecha.Assy
E
Tray open
Screwdriver (small)
F
DV-667A-K
5 6 7 8
67
|
