|
There are currently no product reviews.
 ;
There was no problem at all.After paying i had to wait only a few hours,than i could
download the manual in best pdf-quality.
Thank You !
 ;
I found this service manual to be complete in every detail except for troubleshooting charts. It would be helpful if it had a set of troubleshooting charts; however it is a very good manual otherwise and for the price it is very well worth it.
 ;
Complete manual included schematics layouts and alignment procedure, clear to read and magnify, extremely pleased with manual and owner manual . com's service
 ;
perfect, i am very satisfait for the réception of the sansui r-5l service manual, thank you very much
 ;
Thank you, this is a rare document. Few others have it, but they charge way more for a download.
Great deal (even if you have to wait a few hours to get it).
5
6
7
8
7.1.10 DISASSEMBLY
Note: For performing the diagnosis shown below, the following jig cables for service are required: � GGD1330 �2
A
Diagnosis of the PCBs
Procedures ; JCKB Assy : ¥ � ø � � DVDM Assy : ¥ � ø � [
1 Bonnet and Tray Panel
1 2 3 4 5 6
Remove the Bonnet by removing the five screws. Press the STANDBY/ON button to turn on the power. Press the 0 button to open the tray. Remove the tray panel. Press the 0 button to close the tray. Press the power. STANDBY/ON button to turn off the
26
B
4 3 5
Tray Panel Tray
35
C
How to open the Tray when the power cannot be on
Insert a screwdriver (small) into the slit located at the bottom of the unit, and slide the projection of the drive gear in the loading mecha. assy in the direction of the arrow, as indicated in the photo. If the tray pops out a little, fully pull it out by a hand.
D
Screwdriver (small) Projection
Slit Drive Gear Loading Mecha.Assy
E
Tray open
Screwdriver (small)
F
DV-667A-K
5 6 7 8
67
|