MACKIE HR824 26 pages English-only Service Manual contains:
1) HR824 technical overview with the description of front and rear panel switches.
2) HR824 specs
3) Block Diagram
4) Wiring Diagram
5) Packaging management
6) Spare part & final assembly list (for PCB rev A and B) + exploded view
7) Test Procedures (where, how to measure voltage...) including Test Point diagram on the PCB.
8) IC and Transistor charts.
Excellent guide: very clear, good scan quality enabling us to print readable diagram :-)
Note:
Mackie HR824 make extensive use of surface mount devices (SMD). Service on the HR824 must
only be undertaken by experienced service technicians with the right tools, experience and patience to perform surface mount rework when needed.
This Service manual is very well scanned and its clean to read, no any anti-theft words that un-english could understand. I got my CCD600 working with this manual and it´s clear shematics :)
I was very pleased with the service provided and was surprised at how good the quality was of the manual. I thought it may be a third generation copy or so, but it is as good as the websites that charge 3 times this much. I repair some electronics for family and friends without charge, so this is perfect for me. Thank you very much.
The service was great and the document was also great. Highly recommend!!!!
If anyone has a users manual... Please email me. need one. $ [email protected]
Text excerpt from page 86 (click to view)
Disassembly of the Traverse Mechanism Assy and the Pickup Assy 1 2 3 4 5 6
Remove the Bonnet and Tray Panel. Remove the Front Panel. Remove the Loading Mechanism Assy (Screws �4). Remove the Bridge (Screw �2). Pull out the Tray and remove it while unhooking a Hook. Turn the Short SW to Short side.
7 8 9
Remove the DVDM Assy (Screws �2). Remove four screws. Remove the Mechanism Holder.
8
�4
Mechanism Holder
5
-1 Bridge Hook
4
�2 -1
9
4
-2
5
-2 Bottom View
10 Remove a screw.
RearView
Cautions:
Screw is locked with Silicone adhesive. Please lock it with Silicone adhesive when installs it.
11
Short Open
Remove the FFC Holder with the state which Flexible Cable was atatched. FFC Holder
6
Short SW
10
Silicone Adhesive GEM1037
Traverse Mechanism Assy
11
Caution in the tray insertion
In the Tray insertion, insert it after matching a triangle mark of the Loading Base and a position of pin of the Drive Cam. Triangle mark Loading Base