|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
the manual is in good quality and it's in pdf. manual was send in less then 24h.
regards
mike
;
I would not plug this machine in without finding a manual like this. In addition to setup and normal operating instructions, it has troubleshooting flowcharts, diagrammed mechanical adjustments, and schematics to beat the band. The tech I hand it to would be thrilled to find solder side PCB diagrams with component outlines superimposed, pinouts for every IC chip, and line drawings of transistors, with labeled legs.
As for printing quality, this may be a copy of a copy, but even the finest print when enlarged is very legible. There is a bit of grayed print over a few pages, as if a wet page were placed over it, but the print is still very legible. If you could borrow an original manual and get it printed and bound for 4 to 6 times the cost, you could get better quality. In that case you wouldn't be here. For price, utility, and availability I am rating this manual highly.
;
I received the Manual in a timely manner and it was exactly what I needed.
This is a perfect copy of the Service Manual, The quality is great. I am very
happy. Thank you
;
exactly as they say. Within 24 hours the link to the pages and offcourse it was the right service manual. Super and thanks
 ;
The manual was exact the thing that was promised. My old car stereo is working again thanks to the information supplied.
DVD-Series
2. How to Make FES (Focus Error Signal)1· · · Hologram Foucault Method
Note: The following PD form is slightly different from the actual one. (image only)
(At the time of just focus)
(Close to the disc)
(Far from the disc)
C B A
D + � No error + � + + � �
Actual form has I/V amplifiers here
q
From the deviation of focus, the light shown above (black part) comes back on PD. By receiving the output through a differential amplifier, DC voltage, which responded to defocusing, is output.
3. How to Make Thread Error Signal
When thread does not move..... OL
Bump
PU
Take out the low frequency component for tracking error signals. Tracking Error Signal _ LPF _ Thread Error Signal With this, move the thread to make OL stay around the free neutral point.
22
|
|
|
> |
|
