|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
Some of the pictures in this manual are a bit irritating. I had to dissassemble the unit and some of the screws have different threads, which is not mentioned in this manual. Also some of the drawings of the boards look different than the actual boards.
After all, the manual was very useful. I was able to recalibrate the capstan drive and it is working fine again.
 ;
This manual is very good. 303 pages scanned in a very high resolution. My camera has bad, leaking capacitors which all of the V5000 models are suffering from these days.
There is a huge part list with all capacitors, transistors etc. in this manual which helped me a lot. Otherwise I would not have been able to buy replacement parts.
The dissassembly guide is very enormous and detailed. Unlike on the Panasonic MS1 manual I downloaded here it actually looks like the real parts look. And the screws are labeled correctly, so you shouldn't have any left after the repair. ;)
;
has all the schematics you could need,and very well laid out format also has all part numbers along with an exploded view which is helpful
;
Very nice to have! Now it is no problem to understand how it is put together.
Helps me a lot.
;
good scans, all is clear. all pages in order. recommended
3.2 Check the B/E microprocessor
Are the +3.3V_D1 and +2.5V_D2 of Q102 voltage lines normal? OK
NG
Check the soldering of Q117 and Q116, and the input/output voltage. NG OK Input voltage is OK: Check the soldering of circumference components of Q102. Soldering is OK: Replace Q117 or Q116. Refer to �1. POWER SUPPLY PCB�.
Is the clock waveform of 18pin on Q102 normal? (27MHz. 2Vp-p) OK
NG
Check the waveform of 4pin on Q105. (27MHz 2Vp-p) NG OK Check the soldering of R168 and R153. Check the soldering of X101, circumference components and Q105.
Is the 15pin of Q102 H? OK Are the +3.3V_D1 and +1.8V_D1 of Q101 voltage lines normal? OK
NG
Check the soldering of QU01 (28pin), R156 and C161.
NG
Check the soldering of Q118, and the input/output voltage. OK Input voltage is OK: Check the soldering of Q101. Soldering is OK: Replace Q118.
Is the clock waveform of 18pin on Q106 normal? (27MHz. 2Vp-p) OK
NG
Check the waveform of 3pin on Q105. (27MHz 2Vp-p) NG OK Check the soldering of R170 and R101. Check the soldering of X101, circumference components and Q105.
Refer to B/E 2.
42
|
|
|
> |
|
