|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
Great manual, would not have been able to operate my machine without it!!
James Dawson August 18, 2012
;
excellent value & price! Includes everything you need to know about the NN-C777! I would buy this again.
;
Very satisfied! I was searching for several days, but nope; till I discovered your webside and there it was at a very reasonable price. Keep up the good work!
Paul
Flanders
 ;
Generally speaking good copy; a few pages too hard contrast...
Good service and communication.
;
I purchased the unit from a private party and the original owners manual was not available. Having the ability to download it was extremely helpful and clarified operating the equipment immensely. This is a complicated unit and without the manual I would not have been able to maximize it's potential. Thank you.
Before Using the DV-CP802
Installing the Remote�s Batteries Using the Remote Controller
To use the remote controller, point it at the DV-CP802�s remote control sensor, as shown below.
Remote control sensor DV-CP802
STANDBY/ON
STANDBY
1
Open the battery compartment, as shown.
2
Insert the two supplied batteries (AA) in accordance with the polarity diagram inside the battery compartment.
30�
30�
Ap
ox pr
. 16
ft
. (5
m
)
3
Close the battery compartment.
Notes: � The remote controller may not work reliably if the DV-CP802 is subjected to bright light, such as direct sunlight or inverter-type �uorescent lights. Keep this � in mind when installing the DV-CP802. If another remote controller of the same type is used in the same room, or the DV-CP802 is installed close to equipment that uses infrared rays, the remote controller may not work reliably. Don�t put anything, such as a book, on the remote controller, because the buttons may be pressed inadvertently, thereby draining the batteries. The remote controller may not work reliably if the DV-CP802 is installed in a rack behind colored glass doors. Keep this in mind when installing the DV-CP802. The remote controller will not work if there�s an obstacle between it and the DV-CP802�s remote control sensor.
� Notes: � The supplied batteries should last for about six months, although this will vary with usage. � If the remote controller doesn�t work reliably, try replacing both batteries. � Don�t mix new and old batteries, or different types of batteries. � If you intend not to use the remote controller for a long time, remove the batteries to prevent possible leakage and corrosion. � Flat batteries should be removed as soon as possible to prevent possible leakage and corrosion. � �
16
|
|
|
> |
|
