|
Who's Online
There currently are 5520 guests online.
|
Categories
|
Information
|
Featured Product
|
|
|
|
|
There are currently no product reviews.
;
perfect! you just sent to me the copy in Italian witout even my specification!!!! so you are really smart cooperative and efficient. To my opinion the best place all over to get a manual of electronics!!!!
;
Well Well Well!!!! Good manual perfect for my hobby!!! As Before you have done a very well done work!!!! Thank you
;
Super nice! Good to have a manual in digital format.
;
Great job supplying the manual.
Many of these products weerepretty obscure, so it was great that you had
the manual for it!
;
Great manual, would not have been able to operate my machine without it!!
James Dawson August 18, 2012
INSTALLATION
1 Turn off the power of the personal computer and remove the power cord from the AC outlet, then remove the cover or the front panel. 2 Remove the blank panel installed on the front of the 5.25 inch slot. 3 Install the fixing slide rails on the drive. (When slide rails are required, please contact your shop or the computer manufacturer.) 4 Insert the drive into the slot. 5 When fixing is required, please refer to the instruction manual for the computer. ÷ Please use screws with a length of 5 mm (3/16 in.) or less for mounting. Using longer screws may cause damage on the drive. ÷ When the mounting screws are loose etc., the vibrations from disc rotation may generate ripping noise, to prevent it the screws should be tightened securely.
���
1 å�³æ��计ç®�æ�ºç��ç�µæº�ä¾�åº�å�¨å¹¶ç§»å¼�ç��å�æ��å��æ�¹é�¢æ�¿ã�� 2 移å¼�å®�è£�å�¨ï¼�ï¼�ï¼�ï¼�â��å�£å��ç��空ç�½é�¢æ�¿ã�� 3 å�¨é©±å�¨å�¨ä¸�å®�è£�å�ºå®�æ»�轨ã��ï¼�é��è¦�æ»�轨请ä¸�åº�家æ��计ç®�æ�ºå�¶ é� å��è��ç»�ï¼�ã�� 4 å°�驱å�¨å�¨æ��å�¥å�¡å�£ã�� 5 é��è¦�å�ºå®�æ�¶ï¼�请å��è��个人计ç®�æ�ºç��æ��ä½�æ��å��ã�� ÷ 请使ç�¨é�¿åº¦ï¼� mmï¼�ï¼�ï¼�ï¼�ï¼�â��ï¼�ã��以ä¸�ç��è�ºä¸�é��å®�è£�ã��使ç�¨å¤ªé�¿ç�� ÷ è�ºä¸�é��å�¯è�½ä¼�é� æ��å��驱å�¨ç��æ��å��ã�� å½�å®�è£�ç��è�ºä¸�é��æ�¾å�¨æ�¶ï¼�ç��ç��æ��转æ�¶ç��æ�¯å�¨å�¯è�½ä¼�产ç��æ��大 ç��å�ªé�³ï¼�为äº�é�¿å��è¿�ç§�ç�¶å�µå��ç��请é��ç´§è�ºä¸�é��ã��
PHO NE S
BUS Y
CONNECTIONS
÷ Turn off the power supply of the personal computer. ÷ Connect the power cable from the personal computer. At the time of connection, pay attention to the polarity of the cable. ÷ Connect the IDE interface cable. At this time, confirm that pin 1 of the IDE connector of the drive is connected correctly to pin 1 of the cable. ÷ When a sound card is being used, connect the audio output with an audio cable to the sound card. Be sure to supply electrical power for this product from the personal computer which is connected to it. Do not use any other power supply than the internal one of the personal computer. ÷ ÷ ÷ ÷
������
å®�è£�å��å�³æ��ç³»ç»�å��ç�¸è¿�硬设å¤�ç��ç�µæº�ã�� ä»�计ç®�æ�ºè¿�æ�¥ç�µæº�ç�µç¼�ã��è¿�æ�¥æ�¶ï¼�请注æ��ç�µç¼�ç��æ��æ�§ã�� è¿�æ�¥ï¼©ï¼¤ï¼¥æ�¥å�£ç�µç¼�ã��æ¤æ�¶ï¼�ç¡®å®�å��驱å�¨ä¸�ç��IDEè¿�æ�¥å�¨ï½�ï½�ï½�ã��ï¼� è¿�æ�¥è�³ç�µç¼�ç��ï½�ï½�ï½�ã��ï¼�ã�� å½�使ç�¨å£°å�¡æ�¶ï¼�å°�æ��é�³é¢�è¾�å�ºç��é�³é¢�ç�µç¼�è¿�æ�¥è�³å£°å�¡ã��
请确�����计������计�����产��请� 使�计����以�������
Pin 1 P����
Audio Cable ����
IDE Interface cable IDE����
Power cable ����
�7�
|
|
|
> |
|