I am only search for 5 Minute, by it in 5 Minutes to and get ist in few ours! Best i found in the Internet and my Amplifer is repaired as well! Thank you
Readable text and good copy. Very much needed if you wish to do some repairs on this fine old unit.
Text excerpt from page 26 (click to view)
DCR-DVD200/DVD200E/DVD300
2-29.LB-084 BOARD (REMOVING OF THE EVF)-2
4
Visibility knob (40)
VF slide cabinet (upper) assembly To raise the VF slide cabinet (upper) assembly, insert a flat head (-) screwdriver into the position shown by the arrow. VF slide cabinet (upper) assembly
2A 1 Tapping screw (M1.7 � 3.5) 5 C
3 B
2 A
VF slide cabinet (lower)
2 Open the lock of the VF slide cabinet (lower) in the direction of the arrow A, 3 while slanting the VF slide cabinet (upper) assembly in the direction of the arrow B, 4 remove the Visibility knob (40) from the VF slide cabinet (lower), and 5 remove the VF slide cabinet (upper) assembly by sliding it in the direction of the arrow C.
VF slide cabinet (lower)
RE-ASSEMBLING THE VF SLIDE CABINET
1 VF slide assembly
2 Align the dotted portion of the VF slide assembly with the dotted line of the VF slide cabinet (lower).
VF slide cabinet (lower)
When re-assembling, slide the Visibility knob (40) to the fully right-end beforehand. Visibility knob (40) When re-assembling is completed, the VF slide cabinet (upper) assembly and the VF slide cabinet (lower) are assembled as shown. VF slide cabinet (upper) assembly
3 Slide the VF slide cabinet assembly up to the position in the direction of the arrow where the two claws are locked.
4 Tapping screw (M1.7 � 3.5)
VF slide cabinet (lower) VF slide cabinet (lower) Two claws