|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
the manual is in good quality and it's in pdf. manual was send in less then 24h.
regards
mike
;
I would not plug this machine in without finding a manual like this. In addition to setup and normal operating instructions, it has troubleshooting flowcharts, diagrammed mechanical adjustments, and schematics to beat the band. The tech I hand it to would be thrilled to find solder side PCB diagrams with component outlines superimposed, pinouts for every IC chip, and line drawings of transistors, with labeled legs.
As for printing quality, this may be a copy of a copy, but even the finest print when enlarged is very legible. There is a bit of grayed print over a few pages, as if a wet page were placed over it, but the print is still very legible. If you could borrow an original manual and get it printed and bound for 4 to 6 times the cost, you could get better quality. In that case you wouldn't be here. For price, utility, and availability I am rating this manual highly.
;
I received the Manual in a timely manner and it was exactly what I needed.
This is a perfect copy of the Service Manual, The quality is great. I am very
happy. Thank you
;
exactly as they say. Within 24 hours the link to the pages and offcourse it was the right service manual. Super and thanks
 ;
The manual was exact the thing that was promised. My old car stereo is working again thanks to the information supplied.
Diagnostic Software, Trouble Shooting and Test Instructions
5.3.6 No Digital Out on Optical and Coaxial
DVD580M
5.
EN 23
No Digital output from optical and Coaxial terminal terminal Go Check point : the user's set up manual Observe : check the audio set-up is in digital output mode Yes Check point : pin 10 of CN501 on AV output board Observe : the +5V is presented . Yes Check point : R23 at pin 118 of Ess60x8 Observe : check is the R23 opened. No Check point : CN1at decoder board and CN501 on AV output board Observe : check is any poor contact between CN1 and CN51. No Check point : the copper trace between pin 118 of ESS60x8 to SPDIF at pin 8 of CN1. Observe : check is there any opened trace or poor soldering. Solution : check the output at pin 41of ESS60x8. If no signal from pin 41, change the IC of ESS60x8
CL 26532085-065.eps 180702
.
No
Solution : change the set up
No
Solution : check the 5V supply source from decoder board.
Yes
Solution : Replace R23
Yes
Solution : Replace the connector assembly
No
Figure 5-6 5.3.7 No Digital Out on Optical
No Signal output from Optical terminal but Coaxial output is normal
Go Yes Check point : the R503 on AV output board Observe : check if the resistor is opened Solution : replace the resistor
No Solution : replace the Optical output assembly set
CL 26532085-066.eps 180702
Figure 5-7
|
|
|
> |
|
