PHILIPS DVD Module SD-5.00SA_CH
Service Manual

EN 16

5.

SD-5.00SA_CH

Test Instructions Mono Board DVD-SD5.00SA_CH
Alternatively, there is a check that can be done without A/V board. First, let the decoder generate pink noise on the audio outputs. Table 5-14 Ref. # Command Name 20a Remark

PM3394B ch1

AudioPinkNoiseOn Audio Pinknoise On

1

Measure then these signals on level and frequency. Table 5-15 Signal
CH1 1.00 V~ MTB 500ns ch1+
CL06532065_010.eps 161100

Level between low/high low/high low/high low/high LOW/HIGH

Frequency 48kHz 0.02% 3.072MHz 0.02% 12.288MHz 0.02% N/A N/A

PCMLRCLK PCMSCLK PCMCLK PCMDATA SPDIF

Figure 5-11 PCMDATA

PM3380B

ch1

Put the pink noise off: Table 5-16 Ref. # Command Name 20b
1

Remark Audio Pinknoise Off

AudioPinkNoiseOff

CH1

2.00 V=

MTB20.0ns

ch1+
CL 26532053_067.eps 210502

Figure 5-12 PCMCLK

PM3380B ch1

1

CH1 2.00 V=

BWL MTB100ns

ch1+
CL 16532163_024.eps 230102

Figure 5-13 SPDIF To switch the audio signal OFF, press the STOP button on the front. Without A/V board, the switching levels are as follows: � DATA_LsRs and DATA_CL switch between low and high for pink noise. For sine, this is low. � PCMDATA0, PCMLRCLK, PCMCLK and PCMSCLK switches between low and high for both pink noise and sine. � SPDIF switches between LOW and HIGH