|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
Very nice and real Service Manual, I didn't thought it actually exist in the real world at all.
 ;
VERY NICE FOR COURTESY AND PRECISION!.
tHE SITE IS VERY IMPORTANT FOR ALL DEVICES
vERY GOOD
;
+++ Is is fine, that was what i looking for. Thanks! +++
;
A very good complete archive, i am very satisfied for document.
;
The Service Manual received was helpful. The electronic information is exactly what I needed.
DVD-S53P / DVD-S53PC
8.6.2.
Notice
Procedure for Disassembling the TRV Unit
After changing the 26P FFC, please remove the solder. (refer to Fig. B) 3. Push the tabs on the back and remove the TRV Gear B and A.
1. This section aims to focus on the disassembling methods of some parts in the case that no damage is occurred to optical pickup units. 2. When the optical pickup unit is defective, the overall traverse unit needs replacement. 3. Please note that appropriate actions needs to be taken to prevent static damage. Caution Insert the short pin into the FFC of the optical pickup unit. (See �Caution to be taken in handling the TRV Unit�) 1. Before changing 26P FFC, please weld the short-circuit solder. (refer to Fig. A)
4. Unscrew the screws. 5. Remove the drive rack. Caution Do not dissemble drive rack fixing screws repeatly, otherwise the screws may hard to tighten and affect the accuracy of optical pickups consequently.
2. Remove the connecter, take out the 26P FFC.
6. Remove the solders of the SP motor and the TRV motor.
19
|
|
|
> |
|
