|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
I BOUGHT A PAIR OF INFINITY VINTAGE SPEAKERS THAT REQUIRED TO BE REPAIRED AND THE ELECTRONIC TECHNICIAN ASKED ME FOR THE SERVICE MANUAL.
I TRIED TO GET IT AT THE MANUFACTURER'S SITE WITH NO SUCCESS, SO I STARTED TO LOOK FOR IT IN THE WEB FOR A LONG TIME, UNTIL I FOUND THE SERVICE MANUAL IN THIS EXCELLENT SITE "OWNER'S MANUAL.COM".
NOW I HAVE MY SPEAKERS WORKING AND ENJOYING THE MUSIC I LIKE.
THANKS TO "OWNER`S MANUAL.COM" I RECOMMEND THIS SITE TO EVERYONE.
;
Very quick response. Very good and accurate print quality of the scanned document.
 ;
The service manual was very usable and clear enough to see the individual values of all of the components (unlike some of the service manuals I have gotten in the past from web sites similar to this one). The price was right and the information was greatly appreciated. It helped me with an otherwise very difficult repair. It was much needed and appreciated. A faster turn around on my order would be nice, but I understand the constraints on your staff's time. Thank you for your service.
;
Excellent manual. Helped me out with disassembling and troubleshooting my projector.
;
thanks you are the best.Very good detail, Quick service response. A useful service manual with all details.
DVD-S53P / DVD-S53PC
8.6.2.
Notice
Procedure for Disassembling the TRV Unit
After changing the 26P FFC, please remove the solder. (refer to Fig. B) 3. Push the tabs on the back and remove the TRV Gear B and A.
1. This section aims to focus on the disassembling methods of some parts in the case that no damage is occurred to optical pickup units. 2. When the optical pickup unit is defective, the overall traverse unit needs replacement. 3. Please note that appropriate actions needs to be taken to prevent static damage. Caution Insert the short pin into the FFC of the optical pickup unit. (See �Caution to be taken in handling the TRV Unit�) 1. Before changing 26P FFC, please weld the short-circuit solder. (refer to Fig. A)
4. Unscrew the screws. 5. Remove the drive rack. Caution Do not dissemble drive rack fixing screws repeatly, otherwise the screws may hard to tighten and affect the accuracy of optical pickups consequently.
2. Remove the connecter, take out the 26P FFC.
6. Remove the solders of the SP motor and the TRV motor.
19
|
|
|
> |
|
