|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
The ease of this purchase was a good start. The content of this manual was exactly all I needed to retore my Tandberg 64.
All of the mechanical and electrical information is contained in the manual and the quality of the document makes reading the data easy.
The exerience with the resource has made this my prime source for technical data.
;
Owner-manuals.com is the best Possibility to give vantage HIGH CLASS Elektronic COMPONENTS
a new Life.Thanks alot for your perfekt Service.
;
I am proud of you. In the future, I benefited from your services.
;
I found this manual to be complete in every detail. Besides the schematic it has a complete set of alignment instructions which are easy to understand. It also includes a complete parts list as well as an explanation of how the power supply and safety shutdown circuits operate. Even a schematic of the tuner is included.
 ;
The product was good and just what I needed, however I had moderate difficulty with the down load because the sight would not recognize my pass word. I was finally given a direct link to the manual and that worked.
3-3. SERVO SYSCON CIRCUIT B. A.
Playback picture is not good. YES Noise appears on the screen on the whole. YES Are SW pulse and HA SW applied to PreAmp circuit? NO Noise appears although change cassette tape. YES Check and re-adjust the Path of Deck. YES Is Enve.wavefrom supplied to pin 4 of PT01 YES NO NO Check D.PG input and connector between deck and main PCB. Noise shakes up and down on the screen. YES NO Check pattern NO Check flow A Playback picture is not good. YES
Noise appears although adjusting tracking. YES
Is SW pulse obtained from pin 16 of IC601?
YES
Is CTL pulse applied to pin 73 of IC601.
NO
CTL HEAD height is normal and there is not dust.
NO
Adjust the HEAD height and remove dust.
Check video circuit.
Check connector, Head Amp and Head dust.
NO
Change head
C.
YES YES Check circuit adjacent to IC601. Auto stop during playback. YES Check R668, R669 C508, C509. Is Reel pulse applied to pin 5 and 6 of IC601? YES The voltage of pin 91 of IC601 is not changed. YES NO Check R518 and C511. Is D.FG applied to pin 67 of IC601 YES NO Check connector and D.FG circuits. NO Check reel sensor.
Is CTL pulse input to pin 71 and 72 of IC601
NO
YES
Check IC601
Check IC601.
21
22
|
|
|
> |
|
