|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
the manual is in good quality and it's in pdf. manual was send in less then 24h.
regards
mike
;
I would not plug this machine in without finding a manual like this. In addition to setup and normal operating instructions, it has troubleshooting flowcharts, diagrammed mechanical adjustments, and schematics to beat the band. The tech I hand it to would be thrilled to find solder side PCB diagrams with component outlines superimposed, pinouts for every IC chip, and line drawings of transistors, with labeled legs.
As for printing quality, this may be a copy of a copy, but even the finest print when enlarged is very legible. There is a bit of grayed print over a few pages, as if a wet page were placed over it, but the print is still very legible. If you could borrow an original manual and get it printed and bound for 4 to 6 times the cost, you could get better quality. In that case you wouldn't be here. For price, utility, and availability I am rating this manual highly.
;
I received the Manual in a timely manner and it was exactly what I needed.
This is a perfect copy of the Service Manual, The quality is great. I am very
happy. Thank you
;
exactly as they say. Within 24 hours the link to the pages and offcourse it was the right service manual. Super and thanks
 ;
The manual was exact the thing that was promised. My old car stereo is working again thanks to the information supplied.
DV-4050-B/DVF-R6030-B
DISASSEMBLY FOR REPAIR
1. How to Remove Tray
1. Remove the front panel and flexible cable. Disassemble the X25 and power supply pcb with sub chassis if it is a difficult. 2. Push and hold the lever( )to clockwise and pull barely out the tray to frontwards( ) where the hook of tray( ) meets with guide( ). 3. Push hooks( ), both sides, inwards and release them from guides( ). 4. Pull hooks of tray( ) outwards and remove the tray upwards( ).
1
HOOK ( 5 x2)
6
3
2
5 x2 4
HOOK
Guide
2. How to Assemble Tray
1. Adjust the position of drive gear as figure( ). Check traverse unit is at the lowest position. 2. Load the tray on the loading mechanism. Check the position where the loading gear(A) is free( ) 3. Meet the hooks with guides and push hooks to load the tray( ). 4. Set the right side hook to loading mechanism( ). 5. Set the left side hook to loading mechanism with pulling it outwards( ). 6. Push the tray backwards( ).
5
LOADING GEAR (A) (Free) PROTRUSION OF TRAY
1
ARM
2
DRIVE GEAR
REAR
HOOK
6
4 3
HOOK
GUIDE
3
|
|
|
> |
|
