|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
It`s full copy of a service manual from url http://www.philips.owner-manuals.com/PM3216-service-manual-PHILIPS.html
 ;
perfect! you just sent to me the copy in Italian witout even my specification!!!! so you are really smart cooperative and efficient. To my opinion the best place all over to get a manual of electronics!!!!
;
Well Well Well!!!! Good manual perfect for my hobby!!! As Before you have done a very well done work!!!! Thank you
;
Super nice! Good to have a manual in digital format.
;
Great job supplying the manual.
Many of these products weerepretty obscure, so it was great that you had
the manual for it!
Section
Operating this unit
03
+6 to �4 (or �6) is displayed as the equalizer curve is increased or decreased.
# The actual range of the adjustments are different depending on which equalizer curve is selected. # The equalizer curve with all frequencies set to 0 cannot be adjusted.
+6 to �6 is displayed as the level is increased or decreased.
# You can then select another band and adjust the level.
5 Press BAND to cancel the 7-band graphic equalizer adjustment.
Adjusting 7-band graphic equalizer
For CUSTOM 1 and CUSTOM 2 equalizer curves, you can adjust the level of each band. ! A separate CUSTOM 1 curve can be created for each source. If you make adjustments when a curve other than CUSTOM 2 is selected, the equalizer curve settings will be memorized in CUSTOM 1. ! A CUSTOM 2 curve can be created common to all sources. If you make adjustments when the CUSTOM 2 curve is selected, the CUSTOM 2 curve will be updated. 1 Recall the equalizer curve you want to adjust. See Recalling equalizer curves on the previous page. 2 Press AUDIO to select 7-band graphic equalizer adjustment. Frequency and the level (e.g., 50HZ 0) appears in the display. 3 Press c or d to select the equalizer band to adjust. Each press of c or d selects equalizer bands in the following order: 50Hz�125Hz�315Hz�800Hz�2kHz� 5kHz�12.5kHz 4 Press a or b to adjust the level of the equalizer band. Each press of a or b increases or decreases the level of the equalization band.
Adjusting loudness
Loudness compensates for deficiencies in the low- and high-sound ranges at low volume. 1 Press AUDIO to select LOUD.
2 Press a to turn loudness on. Loudness level (e.g., LOUD MID) appears in the display.
# To turn loudness off, press b.
3 Press c or d to select a desired level. LOW (low)�MID (mid)�HIGH (high)
Using subwoofer output
This unit is equipped with a subwoofer output which can be turned on or off. 1 Press AUDIO to select SUB.W.
# You can also select the subwoofer setting menu by pressing SW on the unit.
Operating this unit
En
2 Press a to turn subwoofer output on. SUB.W NOR appears in the display. Subwoofer output is now on.
# If the subwoofer output phase has been set to the reverse, SUB.W REV will be displayed. # To turn subwoofer output off, press b.
3 Press c or d to select the phase of subwoofer output. Press c to select reverse phase and REV appears in the display. Press d to select normal phase and NOR appears in the display.
43
|
|
|
> |
|
