|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
the manual is in good quality and it's in pdf. manual was send in less then 24h.
regards
mike
;
I would not plug this machine in without finding a manual like this. In addition to setup and normal operating instructions, it has troubleshooting flowcharts, diagrammed mechanical adjustments, and schematics to beat the band. The tech I hand it to would be thrilled to find solder side PCB diagrams with component outlines superimposed, pinouts for every IC chip, and line drawings of transistors, with labeled legs.
As for printing quality, this may be a copy of a copy, but even the finest print when enlarged is very legible. There is a bit of grayed print over a few pages, as if a wet page were placed over it, but the print is still very legible. If you could borrow an original manual and get it printed and bound for 4 to 6 times the cost, you could get better quality. In that case you wouldn't be here. For price, utility, and availability I am rating this manual highly.
;
I received the Manual in a timely manner and it was exactly what I needed.
This is a perfect copy of the Service Manual, The quality is great. I am very
happy. Thank you
;
exactly as they say. Within 24 hours the link to the pages and offcourse it was the right service manual. Super and thanks
 ;
The manual was exact the thing that was promised. My old car stereo is working again thanks to the information supplied.
Section
Audio Adjustments
08
Fine adjusting equalizer curve
You can adjust the center frequency and the Q factor (curve characteristics) of each currently selected curve band (EQ Low/EQ Mid/EQ High).
4 Press E or e to select the desired Q factor. Press E or e until the desired Q factor appears in the display.
2 N�1 N�1 W�2 W
� Pressing 5 or � on the head unit also performs the same operation. Level (dB) Note Q=2N Center frequency Q=2W � If you make adjustments when a curve other than CUSTOM2 is selected, CUSTOM1 curve is updated. Frequency (Hz)
1 Press A and hold unitil frequency and the Q factor (e.g., F 80 Q 1W) appears in the display. � Pressing and holding AUDIO on the head unit also performs the same operation. 2 Press A to select the desired band for adjustment. Low�Mid�High � Pressing AUDIO on the head unit also performs the same operation. 3 Select the desired frequency with 1 or ¡. Press 1 or ¡ until the desired frequency appears in the display. Low : 40�80�100�160 (Hz) Mid : 200�500�1 k�2 k (Hz) High : 3.15 k�8 k�10 k�12.5 k (Hz) � Pressing 2 or 3 on the head unit also performs the same operation.
Adjusting bass
You can adjust the cut-off frequency and the bass level. � In FRT1 mode, bass adjustment affects only the rear output: front output cannot be adjusted. 1 Press A to select Bass. Press A until Bass appears in the display. � Pressing AUDIO on the head unit also performs the same operation. 2 Select the desired frequency with 1 or ¡. Press 1 or ¡ until the desired frequency appears in the display.
40�63�100�160 (Hz)
English Español Deutsch Français Italiano Nederlands
57
� Pressing 2 or 3 on the head unit also performs the same operation. 3 Press E or e to adjust the bass level. Each press of E or e increases or decreases the bass level. +6 � �6 is displayed as the level is increased or decreased. � Pressing 5 or � on the head unit also performs the same operation.
En
|
|
|
> |
|
