|
|
|
Who's Online
There currently are 5631 guests online. |
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
the manual is in good quality and it's in pdf. manual was send in less then 24h.
regards
mike
;
I would not plug this machine in without finding a manual like this. In addition to setup and normal operating instructions, it has troubleshooting flowcharts, diagrammed mechanical adjustments, and schematics to beat the band. The tech I hand it to would be thrilled to find solder side PCB diagrams with component outlines superimposed, pinouts for every IC chip, and line drawings of transistors, with labeled legs.
As for printing quality, this may be a copy of a copy, but even the finest print when enlarged is very legible. There is a bit of grayed print over a few pages, as if a wet page were placed over it, but the print is still very legible. If you could borrow an original manual and get it printed and bound for 4 to 6 times the cost, you could get better quality. In that case you wouldn't be here. For price, utility, and availability I am rating this manual highly.
;
I received the Manual in a timely manner and it was exactly what I needed.
This is a perfect copy of the Service Manual, The quality is great. I am very
happy. Thank you
;
exactly as they say. Within 24 hours the link to the pages and offcourse it was the right service manual. Super and thanks
 ;
The manual was exact the thing that was promised. My old car stereo is working again thanks to the information supplied.
2-1
2-1
DISMANTLING INSTRUCTIONS
Dismantling of the DVD Loader Dismantling of the AV Board, SD6.1 PL 6CH Board and PSU Board
1) The tray can be manually open by inserting a minus screw driver and push the lever in the direction as shown in Figure 1 to unlock the tray before sliding it out. 2) Slide out the tray and remove the Tray Front assembly (pos 110 + pos 111) as shown in Figure 2.
3) Loosen 5 screws to remove the Cover Top (pos 240). - 1 screw each on the left & right side - 3 screws on the rear
1) Loosen 7 screws A (see Figure 3) and uncatch 2 catches C1 (see Figure 4) to remove the AV Board (pos 1001). 2) Loosen 4 screws D (see Figure 4) to remove the SD6.1
3) Loosen 2 screws E and uncatch C2 (see Figure 4) to remove the PSU Board (pos 1004).
4) Loosen 4 screws B (see Figure 4) to remove the DVD Loader.
PL 6CH Board.
Figure 3
Figure 1
Figure 2
Figure 4
|
|
|
> |
|
