SONY DVPNS975V
Service Manual

Changing the password

1 2

Press DISPLAY while the player is in stop mode.
The Control Menu appears.

Controlling Your TV or AV Amplifier (Receiver) With the Supplied Remote
By adjusting the remote signal, you can control your TV with the supplied remote. If you connect the player to an AV amplifier (receiver), you can control the volume with the supplied remote.

Press X/x to select (PARENTAL CONTROL), then press ENTER.
The options for �PARENTAL CONTROL� appear.

3 4 5 6

Press X/x to select �PASSWORD t,� then press ENTER.
The display for entering the password appears.

Notes
� Depending on the connected unit, you may not be able to correctly control your TV or AV amplifier (receiver) using some of the buttons below. � If you enter a new code number, the code number previously entered will be erased. � When you replace the batteries of the remote, the code number you have set may be reset to the default setting. Set the appropriate code number again.

Enter your 4-digit password using the number buttons, then press ENTER. Enter a new 4-digit password using the number buttons, then press ENTER. To confirm your password, re-enter it using the number buttons, then press ENTER.

Controlling TVs with the remote
TV/DVD switch Number buttons [/1 VOL +/� TV/VIDEO ENTER

If you make a mistake entering your password
Press C before you press ENTER and input the correct number.

1 2 3

Slide the TV/DVD switch to TV. While holding down [/1, press the number buttons to select the manufacturer�s code for your TV (see the table below). Release [/1.

74