|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
Exactly what was needed to assess the product - excellent value and great service
 ;
Nice to have the service manual for the Sony DCR-TRV345E now. The document is of excellent quality.
;
MACKIE HR824 26 pages English-only Service Manual contains:
1) HR824 technical overview with the description of front and rear panel switches.
2) HR824 specs
3) Block Diagram
4) Wiring Diagram
5) Packaging management
6) Spare part & final assembly list (for PCB rev A and B) + exploded view
7) Test Procedures (where, how to measure voltage...) including Test Point diagram on the PCB.
8) IC and Transistor charts.
Excellent guide: very clear, good scan quality enabling us to print readable diagram :-)
Note:
Mackie HR824 make extensive use of surface mount devices (SMD). Service on the HR824 must
only be undertaken by experienced service technicians with the right tools, experience and patience to perform surface mount rework when needed.
;
This Service manual is very well scanned and its clean to read, no any anti-theft words that un-english could understand. I got my CCD600 working with this manual and it´s clear shematics :)
;
I was very pleased with the service provided and was surprised at how good the quality was of the manual. I thought it may be a third generation copy or so, but it is as good as the websites that charge 3 times this much. I repair some electronics for family and friends without charge, so this is perfect for me. Thank you very much.
2. DISC REMOVAL PROCEDURE (at POWER OFF)
1) Insert a tapering driver into the aperture of the unit bottom, and move the lever of chuck cam in the direction of the arrow A. (See Fig. 1) 2) Draw out the tray in the direction of the arrow B, and remove a disc. (See Fig. 1)
Lever of chuck cam Aperture
3.
1) 2) 3) 4)
HOW TO SERVICE MB-86 BOARD
Remove the case from the set. (Refer to 2-1) Remove the mechanism deck. (Refer to 2-6) Remove the MB-86 board. (Refer to 2-9) Set the CK-MD board as shown in Fig. 2.
4 Claw
5 CK-MD board
1 Flexible board (CN005)
2 Flexible board (CN001)
B
Tray A
3 Flexible board (CN002)
Fig. 1
Fig. 2
5) Set the MB-86 board as shown in Fig. 3.
1 MB-86 board
3 Two ground point screws
2 STAND
Fig. 3
�5�
|
|
|
> |
|
