|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
The Owner's manual was very helpful. The WEGA is about 35 years old and needed repair.
Your Website is pretty good und easily to handle.
Thank You
Carl-W. Lohmann
;
Perfect. Very good service and very good scanning quality. All sheets are very legible. Thank's
;
My first manual from Owner-Manuals.com but not the last! I am very satisfied with the easy ordering and promt delivery of a manual I did not find anywhere else.
 ;
This manual is very helpfull to use the Power Supply. All technical information has been available.
For service use the circuit diagrams are very good.
Thanks .
;
Very comprehensive document which is a must-have for any Satellit 2100 owner whose set up is somewhat intricate. Due to the bad quality of the pictures that are rather dark and a bit blurred I gave 4-star feedback.
��
1 å�³æ��计ç®�æ�ºç��ç�µæº�ä¾�åº�å�¨å¹¶ç§»å¼�ç��å�æ��å��æ�¹é�¢æ�¿ã�� 2 移å¼�å®�è£�å�¨ï¼�ï¼�ï¼�ï¼�â��å�£å��ç��空ç�½é�¢æ�¿ã�� 3 4 5 ÷ å�¨é©±å�¨å�¨ä¸�å®�è£�å�ºå®�æ»�轨ã��ï¼�é��è¦�æ»�轨请ä¸�åº�家æ��计ç®�æ�ºå�¶é� å��è��ç»�ï¼�ã�� å°�驱å�¨å�¨æ��å�¥å�¡å�£ã�� é��è¦�å�ºå®�æ�¶ï¼�请å��è��个人计ç®�æ�ºç��æ��ä½�æ��å��ã�� 请使ç�¨é�¿åº¦ï¼�ã��ï½�ï½�ï¼�ï¼�ï¼�ï¼�ï¼�â��ï¼�ã��以ä¸�ç��è�ºä¸�é��å®�è£�ã��使ç�¨å¤ªé�¿ç��è�ºä¸�é��å�¯è�½ä¼�é�
INSTALLATION
1 Turn off the power of the personal computer and remove the power cord from the AC outlet, then remove the cover or the front panel. 2 Remove the blank panel installed on the front of the 5.25 inch slot. 3 Install the fixing slide rails on the drive. (When slide rails are required, please contact your shop or the computer manufacturer.) 4 Insert the drive into the slot. 5 When fixing is required, please refer to the instruction manual for the computer. ÷ Please use screws with a length of 5 mm (3/16 in.) or less for mounting. Using longer screws may cause damage on the drive. ÷ When the mounting screws are loose etc., the vibrations from disc rotation may generate ripping noise. To prevent it the screws should be tightened securely.
��驱����� ÷ ��������������转�������产��大����为��� ������请�紧����
��
CONNECTIONS
Ｐ���� ���� Audio Cable
Pin 1
ＩＤＥ����
����
IDE Interface cable 80-wire cable is required for maximum DVD writing speed.
Power cable
为达ＤＶＤæ��ä½³å�»å½�é��度ï¼�请使ç�¨ï¼�ï¼�çº¿ä¼ è¾�线 ï¼�å�³ï¼¤ï¼ï¼¡ï¼�ï¼�ã��æ�°æ�®çº¿ï¼�
÷ å®�è£�å��å�³æ��ç³»ç»�å��ç�¸è¿�硬设å¤�ç��ç�µæº�ã�� ÷ ä»�计ç®�æ�ºè¿�æ�¥ç�µæº�ç�µç¼�ã��è¿�æ�¥æ�¶ï¼�请注æ��ç�µç¼�ç��æ��æ�§ã�� ÷ è¿�æ�¥ï¼©ï¼¤ï¼¥æ�¥å�£ç�µç¼�ã��æ¤æ�¶ï¼�ç¡®å®�å��驱å�¨ä¸�ç��ＩＤＥè¿�æ�¥å�¨ã��ï½�ï½�ï½�ã��ï¼�è¿�æ�¥è�³ç�µç¼�ç�� ï½�ï½�ï½�ã��ï¼�ã�� ÷ å½�使ç�¨å£°å�¡æ�¶ï¼�å°�æ��é�³é¢�è¾�å�ºç��é�³é¢�ç�µç¼�è¿�æ�¥è�³å£°å�¡ã��
请确�����计������计�����产��请�使�计����以���� ���
÷ Turn off the power supply of the personal computer. ÷ Connect the power cable from the personal computer. At the time of connection, pay attention to the polarity of the cable. ÷ Connect the IDE interface cable. At this time, confirm that pin 1 of the IDE connector of the drive is connected correctly to pin 1 of the cable. ÷ When a sound card is being used, connect the audio output with an audio cable to the sound card. Be sure to supply electrical power for this product from the personal computer which is connected to it. Do not use any other power supply than the internal one of the personal computer.
-7-
-7-
|
|
|
> |
|
