|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
Hi, thankyou for providing the Nordmende Globetrotter original manufacturer's repair manual. Quality is very good and sharp - the PDF file was comfortably small to download. The only question is: why did it take so long to become ready for download?? Many thanks anyway, I fixed the fault in the radio thanks to the circuit.
regards: Nick
 ;
This was super service.Ordered this manual and was reading the download an hour later
;
as always, rapid and efficient, very good and clear prints
details clearly visible keep going this way!!!!!!
;
I expect a wonderful result as alaways!!!!!!
Usually is much faster....
;
Wow very wonderful and clear!!!! I will always trust them
RE-WRITE FOR DVD FIRMWARE
1. Connect the set to TV Monitor. 2. Turn on the POWER, and set to the DVD mode. 3. Confirm that the �No Disc� will be appeared on the screen. A disc is already inserted, eject the disc and power it on again. 4. Press both Channel button (2) on the remote control and the STOP button on the set for more than 2 seconds. 5. The tray will open automatically. 6. Press OPEN/CLOSE button on the set to check if all the keys on the unit do not function. NOTE: To check if DVD Write mode is set. 7. Place the Up-Date Disc and close the tray by hand. (Refer to SERVICING FIXTURE AND TOOLS) 8. Automatic read will start and "SDRAM writing" will be displayed on the screen. 9. Approx. 7 seconds later, the tray will open automatically. Remove the Up-Date Disc. The display will change to �FLASH writing�. 10. Then, Approx. 2 minutes 30 seconds later, the above indication will disappear and the tray will close automatically. When the "Please Reboot" appears on the screen, the writing will be finished. NOTE: Do not turn off the unit on the way or push the tray by hand to close it. Up-Date error will happen and can not be done with the Up-Date of Up-Date Disc. 11. Unplug the AC cord, then plug it in. After the write, set to the initializing of shipping. 12. Turn on the POWER, and set to the DVD mode. 13. Press both CH UP button on the set and the PLAY button on the set for more than 2 seconds. 14. After the finishing of the initializing of shipping, the unit will turn off automatically. CHECK FOR THE FIRMWARE VERSION 15. Turn on the POWER, and set to the DVD mode. 16. Press both CH DOWN button on the set and the DVD/VCR button on the set for more than 2 seconds. Information screen will be displayed on the TV Monitor. (Refer to Fig. 1) 17. When the changed version displays, the Re-write will be completed. 18. Turn off the power Firmware Version
Vaddis Ver. C.Sum Accum DVD RXM53021 06010040 000000 Timer OEC0154A108B 121B 0000
MATUSHITADVD-RAM SW-9573 MR19 Region-1
Fig. 1
C5-1
D-VR4SU/D-VR4SC
|
|
|
> |
|
