PIONEER DVR-510H-S/RLXU
Owner's Manual

06

Recording

� If Optimized Rec (see Optimized Rec on page 101) is set to On, the recorder will adjust the recording quality to try and fit the recording on the disc. If the recording will not fit onto the disc even on MN1 recording quality then the Recovery Recording feature will automatically make the recording to the HDD instead. � For an HDD timer recording, if there are already 99 titles on the HDD, the message Title Over appears. � If a timer program overlaps another in the list, the message Overlap appears. � 6 Hour Over is displayed if a recording over 6 hours is set. 5 To exit the timer recording screen, press HOME MENU. Note � When Optimized Rec is On, Optimized Recording takes priority over Recovery Recording when recording to DVD. In other words, if there�s not enough space on the DVD disc for the recording to complete on the recording quality set, the recorder will first try and adjust the recording quality. If the recorder can�t compensate using a lower recording mode setting, then the HDD is used for Recovery Recording. � If there is very little free space left on the HDD, an Auto Replace Recording may not complete successfully. � If the HDD is being used for playback or high-speed copying when an Auto Replace Recording is due to start, the new timer recording will not replace the old one. However, the next time the timer recording starts, both of the older two programs will be erased.
G-CODE

HDD

DVD

CLEAR

ENTER

ì

REC MODE

1

Press �G-Code� to display the G-Code program

screen. You can also access this screen from the Home Menu (press HOME MENU, select Timer Recording, then G-Code).
G-Code G-Code# Rec Mode MN21 39924 0 9 to input

REC MODE to change to change level Daily Weekly HDD to change DVD to change

Rec Times

Once HDD

Timer recording using the G-Code� programming system
This system makes programming timer recordings very simple. Most TV guides publish G-Code programming numbers with their program details. If you want to make a timer recording of a program, you just input the corresponding code. The date, start, stop and channel settings are made automatically. All you have to do is tell the recorder the recording mode, and whether it�s a once-only recording or a regular recording.

Rec to

� Use the number buttons to enter the G-Code programming number. (To clear the last digit entered, press CLEAR.) � Press REC MODE to change the recording quality (see also Setting the picture quality/recording time on page 46). If Manual Recording is on, then you can also select the MN setting. � Use the / (cursor left/right) buttons to select the Once, Daily or Weekly recording option. � Press HDD to record to the hard disk drive, or DVD to record to a DVD. 2 After making the settings, press ENTER. The program details are shown at the bottom of the screen for a few seconds then the screen is automatically exited.

50
En