|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
About one hour after checkout, the manual was available for download. Clear reading and detailed. Thanks
;
Excellent transaction - clean document received - Thanks a lot
;
Manual is in German but complete. I needed this one to fix a long lasting problem with the internal PSU of the camera. Most of the capacitors begin to leak after a few years wich results in the inability to power on the camera. When you try to turn it on the power led flickers and the unit directly turns off. Thanks to this manual I was able to locate all bad cap's and to dis- and reassemble the camera without any problems.
 ;
We received the manual in a timely manner and it was exactly what we were expecting.
;
Excellant, finally this is want I need and searching for The service manual is fantastic and thank you to owner-manuals.com and its service. Price is reasonable. It's a bit slow on my end in downloading but manage to receive the whole manual without a break. once again, thanks.
Disassembly and Reassembly > Checking Mode after Reassembling Deck Mechanism
4-5 Checking Mode after Reassembling Deck Mechanism
After disassembling the deck mechanism, check the positions of the following gears when reassembling it: If the positions of gears drift, the deck mechanism will not operate normally. Turn the cam gear with the L/D motor assembly removed, and make sure that loading and unloading are performed normally. 1) Make sure that hole (A�) in chassis on the surface of deck mechanism is aligned with hole (A) in cam gear: If they are not aligned, remove the L/D motor assembly, and then turn the cam gear until the holes are aligned. 2) Make sure that the small hole in cam gear on the back of deck mechanism is aligned with hole (B) in drive gear: If they are not aligned, remove the drive gear, align their positions, and then reassemble the gears.
L/D Motor Ass'y
Cam Gear
(A') (A) Hole in Chassis Hole in Cam Gear
Top View of Deck Mechanism
Fig. 4-5-1 Cam Gear Position Alignment
Cam Gear
(B) Drive Gear
Bottom View of Deck Mechanism
The holes in cam gear and drive gear must be aligned.
Fig. 4-5-2 Drive Gear Position Alignment
4 - 18
|
|
|
> |
|
