|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
the manual is in quite good quality and it's in pdf. manual was send in less then 6h.
 ;
Absolutely top, I've got now all Service-Manuals I'll need to repair my Mackie-Mixer!
;
The service manuel is very helpful, we where able to restore the device to its working operation again.
;
Great quality complete service manual!!! complete parts list and drawings
;
Again a great job. I never been disilluted from them! Clear scheme, complete and very good for repairing!
SECTION 2
CIRCUIT ADJUSTMENTS
1. SERVO CIRCUIT
ITEM MODE ADJUSTMEN T POINT R592 CHECK POINT PJ01 V.OUT PT01 Pin 3 TEST EQUIPMENT TEST TAPE INPUT SIGNAL
PLAYBACK PHASE
PB
Oscilloscope
DN-2
Location of Adjustment Parts
* PCB MAIN PJ01
Observation Waveform
* HORIZONTAL AXIS. : 0.1 * VERTICAL AXIS : 5V/Div (CH1) 0.5V/Div (CH2)
Rising edge of SW. Pulse PT01 #3 CH 1 SW.PULSE
+
R592
6.5H
CH 2 VIDEO OUTPUT
**[Adjustment Procedure]** (1) Preparation ¨çInsert Test tape.(DN-1) ¨èSet the oscilloscope to the CHOP mode. Connect CH1 to the SW PULSE (PT01#3) and CH2 to the VIDEO OUT (PJ01) and trigger the with the signal from CH1. (2) Adjustment Adjust R592 to trigger the complex video signal of CH-2 to CH-1 H.SW so that the distance from A(B) Head selection point of H.SW signal to the starting point of V-sync signal is 6.5 ±0.5H.
|
|
|
> |
|
