|
There are currently no product reviews.
 ;
The manual is great help for me, i'm happy to have it,thanks
 ;
Very pleased with manual except that a few more details in the drawings might make the job (not yet done, tut-tut) easier. Should be adequate though. Actually I didn't have to pay for this anyway as I was given credit for another item that wasn't quite complete. Good service, then.
;
Very useful manuals, somewhere graphics not very clear!
;
A great manual; it contained all the information I required and allowed me to restore the receiver to full working condition!
;
Very good expirience with owner-manuals.com.
5 Stars; In future if necessary, i´ll download manuals on this site.
DV-SP502/502E SERVICE PROCEDURES-2
2. Safety-check out
(Only U.S.A. model) After correcting the original service problem perform the following safety check before releasing the set to the customer Connect the insulating-resistance tester between the plug of power supply cord and terminal GND on the back panel. Specifications: More than 10M ohm at 500V
INITIALIZING
Factory-shipped condition. Connect the power cord to inlet terminal. Push button "ON" (Mechanical SW). Lighting the LED condition. Press the [STOP] and [STANDBY] same time with NO DISC condition. Push button "STANDBY". Pull out the power cord.
REMOVE THE SOLDER OF LASER DIODE SHORT
When replace the mechanism or DVD main PC board. Shorting the solder of Shot-circuit land. (2 positions)
Mechanism
Short Land
|
