|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
Very fast and perfect delivery. Clear and well scanned. A lot of work professionally realized.
Again thak you a lot
 ;
This manual is accurate and of high quality. It is only volume 2 of the service manual. This is schematic, parts lists, and exploded mechanical drawings. The theory of operation and the diss-assembly instructions are in volume 1. The unit can be tricky to dis-assemble portions of so the volume 1 manual can be important. The product description of the manual is accurate but it does not say anything about volume 1 and the image of the front page does clearly say Volume 2.
;
Wellll again thank you very much fast and effective. Clear and well done for such an old TV!!!!
;
It has all the information you will need to fix it. The main circuit diagram is only A4 but being a PDF, you can print it to any size - I did it on two sheets of A3 and it didnt lose any detail - just made it readable when pinned up above the bench. I've found the fault, just need to buy some obscure bits to get it going again!
I cant fault the process, I paid for the manual in the morning and it was ready to download by lunch time.
;
Very good copy in a 54 pages PDF archive. This is my sixth purchase here. :)
C. Auto PG adjustment
1. Purpose : PG shifter variable resistor is deleted thanks to adding 6.5H automatic adjustment. 2. How to make SW.P
D.PG
D.FG
A
SW.P
A : PG DELAY
3. Why to adjust PG delay : To compensate mechanical tolerance by adjustment.
4. Concept of automatic adjustment To adjust 6.5H means to set the time from SW.P to V.Sync at 6.5H. We can do that by compensating the undesired time as long as we can check the time between the two. The micom check the gap between SW.P and V.Sync by resolution of 2 § �(1H à 64 usec ) . After comparing the checked time with actual 6.5H, the difference is compensated and then SW.P is output. With this kind of method, we can get the effect same as manual adjustment in the past. result is saved in an EEPROM so as to keep the data in spite of RESET mode. And also, all the
5. Process In Automatic adjustment mode, The micom makes progress to fix PG delay to 9.14 degree maximum range as controllable as, to get average time from to check SW.P and V.SYNC�s time be read from Tape as 4 times, to compensate the time equivalent to 6.5H. Under the time compensated condition, The micom makes recheck SW.P and V.SYNC�s time, if the result is in the range 6.5H ¡ ¾.0H, then the DATA will be saved to EEPROM, or not repeat this 1 process with adjusted state
DEC T-30 LINE TECHNICAL MANUAL
8
DAEWOO VCR R&D
|
|
|
> |
|
