I purchased the unit from a private party and the original owners manual was not available. Having the ability to download it was extremely helpful and clarified operating the equipment immensely. This is a complicated unit and without the manual I would not have been able to maximize it's potential. Thank you.
Being a user of older radios of many kinds, preferring them over more modern rigs, this manual was invaluable in the programming of my two. I now know for certain what the assorted buttons functions are, and am very grateful to have found this excellent site. Many thanks for your assistance, Tony.
5 star quality on these downloadable manuals. Easy to read and all the information is there. A must when doing a custom install or needing to service your precious old school electronics.
Text excerpt from page 21 (click to view)
Adjusting the worktop
You can move the worktop forward or backward by 25 mm in order to align the machine with other kitchen units. Simply unscrew the two rear retaining screws, move the top to the required position and then retighten the screws.
Fitting Under a Counter
(kitchen worktop or sink) By removing the machine�s worktop, you can install it under a close fitting sink unit or a pre-existing top, providing the dimensions of the recess correspond to those shown in the picture.
IN26
570÷600
Proceed as follows:
Remove the machine�s worktop by unscrewing the two rear retaining screws, pull from the front and slide out the rear slots, lifting the worktop. Insert the machine after adjusting height and levelling with the adjustable feet. When inserting the machine, ensure that the water inlet and drain hoses are not kinked or squashed.
IN05
600
Fitting a decor panel on the door
The door of this machine has frames for fitting a plastic laminate decor panel in the colour required to match the dishwasher with the rest of the kitchen furniture. If you wish to do this you must provide the panel yourself, that must have the following dimensions. Width: Height: Max thickness: 588 mm 586 mm 4 mm
To fit the panel
Take the door frame off after removing the retaining screws around the edge. Position the panel, refit the frame and tighten the retaining screws around the edge. Note: The panel should be fitted before positioning the machine.
