|
|
|
Who's Online
There currently are 5701 guests online. |
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
Immediate response with excellent service - highly reccommended
;
Correct manual received and of good quality but the contents of the file for the Service Manual for the same monitor is for a 20" TV not the RGB Monitor.
;
The owners manual for the Pioneer VSX-D603S was exactly what I needed. I received it in a timely manor and it was priced fairly. I definately will use your servise again. Thank You
;
This is a great manual. It was easy to read and very accurate. The size of the manual is small so email is no problem. I highly recommend it. The manual is very hard to find other than this website.
;
Manual was complete and available promptly, since I had lost my original manual. Very good response.
BEFORE YOU CALL FOR SERVICE
Check these points if your dishwasher... Leaves food soil on dishes � Check to see that the water heater is set to deliver 140°F water at the faucet. � Turn on hot water at kitchen sink before running the dishwasher to be certain that hot water is entering the first wash cycle, � Select Temp Boost option if available. � Check water hardness. For extreme hard water conditions it may be necessary to install a mechanical water softener, � Use the amount of detergent recommended for your water hardness, and be sure it is put in the dispenser as directed previously, � Use fresh high phosphate detergent that is not caked. Store detergent in cool, dry place, � Select proper cycle for soil level of dish load. � Be sure dishes are loaded properly with nothing blocking the path of the wash arms, center spray nozzle or detergent dispenser. � Check for nesting of dishes that prevents water from reaching all surfaces. � Check to make sure glasses are not loaded over prongs, � On convertible models make certain the hot water faucet is turned on. Leaves glassware cloudy or spotted Does not dry properly � Be sure the Heat Dry option is selected. � Use a rinse agent such as Jet-Dry. � Check to see that the water heater is set to deliver 140°F water at the faucet nearest the dishwasher. Run water and check temperature with a candy thermometer. � Increase detergent use according to water hardness. � Check for improper loading and do not overload. Dishes should not nest together. � Plastic items have a porous surface and tend to hold water. Towel drying may be required. � Glasses, cups, etc., with concave bottoms will hold water. � When using Quick Cycle (select models), towel drying is required. Stains or discolors dishes � Aluminum utensils can leave marks when they rub against other things. Load properly. � Iron deposits in the water can leave a yellow or brown film on dishes. You may desire to have a special filter installed in the water supply line, or periodically use RoVer Rust Remover (see Water Conditions). Cycle takes too long - (Heating Delay light
� Adjust the detergent amount to your water hardness as described earlier in this book. Avoid overuse or undernse of detergent, � Check to see that the water heater is set to deliver 140°F water at the faucet nearest the dishwasher. Avoid extremely high or low temperatures. � Use a rinse agent such as Jet-Dry. � Do not pre-rinse dishes before loading them into the dishwasher. � Refer to Water Conditions for more information,
stays on) � Temp Boost option has been selected which will extend the cycle to heat water thermostatically. � Check to see that the water heater is set to deliver 140°F water. "'Clean" light remains on (select models) � On timer models turn dial slightly clockwise until light shuts off. � On touch control models Clean stays lit until the door has been open longer than 30 seconds.
PAGE 14
|
|
|
> |
|
